SMC Networks SMC8150L2 Lacp port-priority, Show lacp, This command displays Lacp information

4 Command Line Interface

lacp port-priority

This command configures LACP port priority. Use the no form to restore the default setting.

Syntax

lacp {actor partner} port-priority priority no lacp {actor partner} port-priority

•actor - The local side an aggregate link.

•partner - The remote side of an aggregate link.

•priority - LACP port priority is used to select a backup link. (Range: 0-65535)

Default Setting

32768

Command Mode

Interface Configuration (Ethernet)

Command Usage

•Setting a lower value indicates a higher effective priority.

•If an active port link goes down, the backup port with the highest priority is selected to replace the downed link. However, if two or more ports have the same LACP port priority, the port with the lowest physical port number will be selected as the backup port.

•Once the remote side of a link has been established, LACP operational settings are already in use on that side. Configuring LACP settings for the partner only applies to its administrative state, not its operational state, and will only take effect the next time an aggregate link is established with the partner.

Example

Console(config)#interface ethernet 1/5

Console(config-if)#lacp actor port-priority 128

show lacp

This command displays LACP information.

Syntax

show lacp [port-channel] {counters internal neighbors sysid}

•port-channel- Local identifier for a link aggregation group. (Range: 1-32)

•counters - Statistics for LACP protocol messages.

•internal - Configuration settings and operational state for local side.

•neighbors - Configuration settings and operational state for remote side.

•sysid - Summary of system priority and MAC address for all channel groups.

4-136