SMC Networks SMC8150L2 Port Configuration, Displaying Connection Status, Field Attributes Web

3 Configuring the Switch

CLI – This example allows SNMP access for a specific client.

Console(config)#management snmp-client 10.1.2.3			4-27
Console(config)#end
Console#show management all-client
Management IP Filter
HTTP-Client:		End IP address
	Start IP address
-----------------------------------------------
SNMP-Client:		End IP address
Start IP address
-----------------------------------------------
1.	10.1.2.3	10.1.2.3
TELNET-Client:		End IP address
Start IP address
-----------------------------------------------

Console#

Port Configuration

Displaying Connection Status

You can use the Port Information or Trunk Information pages to display the current connection status, including link state, speed/duplex mode, flow control, and auto-negotiation.

Field Attributes (Web)

•Name – Interface label.

•Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)

•Admin Status – Shows if the interface is enabled or disabled.

•Oper Status – Indicates if the link is Up or Down.

•Speed Duplex Status – Shows the current speed and duplex mode. (Auto, or fixed choice)

•Flow Control Status – Indicates the type of flow control currently in use. (IEEE 802.3x, Back-Pressure or None)

•Autonegotiation – Shows if auto-negotiation is enabled or disabled.

•Media Type3 – Media type used for the combo ports 21-24 (SMC8126L2) or 45-48 (SMC8150L2).

(Options: Coppper-Forced, SFP-Forced, or SFP-Preferred-Auto; Default: SFP-Preferred-Auto)

•Trunk Member4 – Shows if port is a trunk member.

•Creation5 – Shows if a trunk is manually configured or dynamically set via LACP.

3.Port information only.

4.Port information only.

5.Trunk information only.

3-76