Xerox ls 32270 instruction manual Installation of the Xerox LS, Knowing the Front Panel

Page 8

Installation

Xerox LS 3270

2. Installation of the Xerox LS 3270

This chapter starts with an overview of the functionality of the front panel. Then follows a description of how you connect the Xerox LS 3270 box to a printer.

NOTE:

Before you start the installation, make sure that the rotary switch is set to the required emulation (PCL is default). See the location of the switch in section

2.1.below.

2.1.Knowing the Front Panel

PAR

CU

Centronics Ouput Port

B A T

 

TEST

External Power Supply

 

Coax Port

Connector

Rotary Switch

Centronics Share Port

Fig 2-1 Xerox LS 3270 Front Panel

 

COAX

The coax cable is connected to the host which communicates in accordance with the 3270 protocol.

PARALLEL/CENTRONICS OUT

The parallel/Centronics output port is connected to the parallel/Centronics in put port on the target printer.

- 8 -

Image 8
Contents Rank Xerox Electronic Documentation September PrefaceRelated Manuals Table of Contents What is the Xerox LS 3270? PCL Driver DefaultIntroduction to the Xerox LS PCL or FSL output driverXerox LS 3270 Features Changing the DriverInstallation Requirements Supported Control UnitsPaper Size Default US/EU Operating EnvironmentInstallation of the Xerox LS Knowing the Front PanelPrinter Dependency InstallationPre-Installation Information Installation Procedure Below follows the procedure for installing the Xerox LSAutomatic Power Supply Control Xerox LS 3270 and its side panelTesting PCL driverTimeout Indicators of the Xerox LS Operation of the Xerox LSCU Contact with Control Unit PAR Parallel inputSpecifying Timeout 3NVRAM = Non-volatile RAM Programming theXerox LS Setup functions supported in PCL mode Where % is the defined ESC character Send Logo ESC FeaturesWhere % is the defined ESC character User Settings Functions X-Functions Test functions T-FunctionsEngineering Functions FunctionsSetup Functions supported in FSL mode ESC Features User Settings Functions X-Functions FSL Setup via Xerox LS 3270 Parallel Port ??%%Y100,10,’SHARESTRING’%%X1Deactivating the Y249 Engineering Function Limitations when Y249 is activeActivating the Y249 Engineering Function Updating firmware Error Messages Recoverable ErrorsThere is no Space Left Dynamic Area Non-Recoverable Hardware Errors PCL Test Printout Busy Timeout Timeout CoaxTest Printouts Proportional Spaced = Active Gfid =Busy Timeout FSL Test PrintoutAppendix A. Quick Reference Guide to FSL Functions FSL N/SLPI LPI FSL N/SEbcdic Y10 Y12 Y13 Are wrappedY19 Y22Name Syntax Parameters Deviations Y35 Y41 EABY39 IRQ Y47Eeprom ESCEEPROM/RAM Y54 Y52Y53 Y55 Y56Y59 Y60HEX Y71Y74 PCL mode FSL modeAscii HEX N2dataY79 APLName Syntax Parameters Deviations Y91 Y92Y93 Y94Y96 Y98APO Y110Y113 Y111Y112 Y119 Y114Y115 Data Re. T2RAM Appendix B. Selected Xerox Products Coax Supported Printers ExternalIndex Coax