JVC AV-20F703, AV-24F703 manual DVD setup, DVD Player Search Codes Function

REMOTE CONTROL (CONTINUED)

DVD setup

The remote control is programmed with DVD codes for power on, power off, play, stop, fast-forward, rewind, previous chapter, next chapter, tray open/close, and still/pause operation.

1)Find the DVD player brand from the list of codes shown below.

2)Slide the first 2-way selector switch to “TV ” and the other 2-way selector switch to “DVD ”.

3)Press and hold down the DISPLAY button.

4)With the DISPLAY button held down, enter the first code number listed with the 10 key pad.

5)Release the DISPLAY button.

6)Confirm the operation of the DVD player.

•If your DVD player does not respond to the first code, try the others listed. If it does not respond to any code, try the Search Codes Function as shown below.

•After you program your remote, some DVD buttons may not work properly. If some buttons do not work properly, use the remote control which came with your DVD player.

DVD Player	CODES	DVD Player	CODES
Aiwa	043	Raite	033
Apex	040	RCA	021, 026
Denon	020, 037	Sampo	034
Hitachi	030, 031	Samsung	030
JVC	000	Sharp	028
Kenwood	035	Silvania	038
Konka	039	Sony	024, 045, 046, 047
Mitsubishi	025	Technics	020
Onkyo	041	Toshiba	023
Oritron	044	Wave	042
Panasonic	020	Yamaha	020
Philips	023, 036	Zenith	027, 032
Pioneer	022

DVD Player Search Codes Function:

1)Slide the first 2-way selector switch to “TV ” and the other 2-way selector switch to “DVD ”.

2)Press the DVD POWER and RETURN buttons. Hold for at least three seconds and release.

3)Press DVD POWER, see if the DVD player responds.

4)If there was a response, press RETURN. The operating codes are now set. If there was no response, repeat Step 3. If you repeat Step 3 a total of 30 times without a response, use the manufacturers remote control which came with the DVD player.

5)Press RETURN to exit.

10