JVC HR-S9600EU Access Manual, Channel SET Screen, Select NEW Station, Switch Stations

60ENSUBSIDIARYSETTINGS(cont.)

Set Stations (A)

Set station names that are registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 58 to access the Confirmation screen before continuing.

	SELECT ITEM
1 Press %Þ @ #until the item you want begins blinking.
	ACCESS MANUAL
	CHANNEL SET SCREEN
2 Press OK twice.
	SELECT NEW STATION
	Press # until the station
	name (ID) begins blinking,
	then press %Þ until the	PR CH ID FINE DECODER
3 new station’s name (ID)		06 CH45 – – – – +/– OFF
	you want to store begins
	blinking.
	Registered station names	[5°] : CHANGE ID
	(☞ pg. 61) appear as you	[°°] : CURSOR +=
		: OK
	press %Þ.	[MENU] : EXIT
4	SWITCH STATIONS
	Press OK.

●The Confirmation screen appears.

●Repeat steps 1 through 4 as necessary.

CLOSE CONFIRMATION SCREEN

5 Press MENU.

Set Stations (B)

Set station names other than the ones registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 58 to access the Confirmation screen and then perform step 1 and 2 of "Set Stations (A)" on the left before continuing.

SELECT STATION NAME

CHARACTER

1	Press #until the first letter
		of the station name begins
		blinking.		PR	CH ID	FINE DECODER
				06	CH45 ARD	+/– OFF
				[5°] : A-Z, 0-9
				[°°] : CURSOR +=
					: OK
				[MENU] : EXIT
		ENTER NEW CHARACTER
	Press %Þ to cycle through the characters (A–Z, 0–9, –,
		*, +, (space) ) and stop when the desired character
2 is indicated, then press			#to enter. Enter the remaining
		characters the same way (maximum of 4).
		After entering all characters, press OK.

●The Confirmation screen appears.

●If you make a mistake, press @until the incorrect character begins blinking. Then enter the correct character by pressing %Þ.

CLOSE CONFIRMATION SCREEN

3 Press MENU.