JVC HR-S9500EK setup guide Repeat Playback, Ntsc Playback, Retake, Next Function Memory

44

1 2

4 5

7 8

0

LAY 1

REW

STOP

JOG

ADVANCEDOPERATIONS (cont.)

	Repeat Playback
	Your video recorder can automatically play back the whole tape
	50 times repeatedly.
3
2
6		START PLAYBACK
9	1
		Press PLAY.
4
	2	ACTIVATE REPEAT PLAYBACK
		Press PLAY and hold for over 5 seconds, then release.
FF		● The Play indicator ( ) on the display panel blinks
PAUSE		slowly.
		● The tape plays 50 times automatically, and then stops.
	3	STOP PLAYBACK
		Press STOP at any time to stop playback.
3
JOG/SHUTTLE

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

Retake

You can cut out unnecessary parts of a TV programme while you're recording it.

End of programme		Beginning of programme
Programme	Unnecessary	Unnecessary	Programme
	part	part

Recorded part

Go back to end of programme to cut out unnecessary part

1	ENGAGE RECORD-PAUSE MODE
	Press PAUSE during recording.
2	LOCATE START POINT
	First press JOG/SHUTTLE and turn the JOG dial (or
	hold down REW or FF) and release it when you reach
	the point where you want to resume recording.
	* Your recorder returns to the Record-Pause mode.
3	RESUME RECORDING
	Press PLAY when you wish to resume recording.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY.
	● "NTSC→PAL" appears on the screen for about 5
	seconds.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and tape remaining time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.
	● Depending on the type of TV, the top and bottom
	portions of superimposed displays may be cut off
	during NTSC playback.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press within 2 seconds.