JVC SR-V10E specifications Other Problems

Page 61

			EN 61

	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
7.	“ “, “” and “$“ on the front	● The loaded cassette has had its record	Set “REC SAFETY” to “OFF” ( pg. 48),
	display panel won’t stop blinking.	safety tab removed and “REC SAFETY”	or using adhesive tape, cover the hole
		is set to “ON”.	where the tab was removed.
		● The end of the tape was reached during	The programme may not have been
		Automatic Satellite Programme	recorded in its entirety. Next time make
		Recording.	sure you have enough time on the tape to
			record the entire programme.

OTHER PROBLEMS
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Whistling or howling is heard from the	● The camcorder’s microphone is too	Position the camcorder so its microphone
	TV during camcorder recording.	close to the TV.	is away from the TV.
		● The TV’s volume is too high.	Turn the TV’s volume down.

2.	When scanning channels, some of	● Those channels have been designated to	If you need the skipped channels, restore
	them are skipped over.	be skipped.	them ( pg. 52).

3.	The channel cannot be changed.	● Recording is in progress.	Press 9 to pause the recording, change
			channels, then press 4 to resume
			recording.

4.	Channel settings that were made	● After the manual settings were made,	Perform manual setting again.
	manually seem to have changed or	Auto Channel Set was performed.
	disappeared.

5.	No channels are stored in the	● The TV aerial cable was not connected	Turn off the recorder once and connect
	recorder’s memory.	to the recorder when Auto Set Up was	the TV aerial cable to the recorder
		performed.	properly, then turn on the recorder again.
			Then perform Auto Set Up again
			( pg. 12).

6.	Buttons and controls do not function at	● Mode Lock is activated.	Press and hold OK for more than 5
	all.		seconds to cancel Mode Lock. ( pg. 17,
			20)

ATTENTION

This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After checking the cassette, operate the unit as usual.

Image 61

Contents Video Cassette Recorder Safety Precautions Moisture Condensation Front View Connector coverRear View Close the battery cover until it clicks in placeFront Display Panel ON-SCREEN Display Remote Control Operating JVC TVs How To Use10 EN Check the contentsSituate the recorder Connect the recorder to TVVideo Connection 8To connect to a TV with S-VIDEO/AUDIO in connectors12 EN Auto Set UpTurn on the recorder Select your countryConfirm/Set video channel Perform Auto Set UpWith RF connection With AV or S-VIDEO connection14 EN Results of Auto Set Up appear on the front display panelJust Clock Last-Function MemoryBasic Playback Slow Motion 16 ENHigh-Speed Turbo Search Pause during playbackVariable Speed Search Mode Lock To prohibit any operations during playbackIndex Search Skip SearchNext Function Memory 18 ENRepeat Playback Manual TrackingChoose a programme Recording Resume FunctionSet the tape speed Start recording20 EN Mode Lock To prohibit any operations during recordingWatching Another Accidental erasure preventionRepeat Recording Tape Remaining Time22 EN Engage the S-VHS ET modeSuper VHS ET S-VHS ET Receiving Stereo and Bilingual ProgrammesRecording Playback24 EN Series PlaybackSR-V10E-1 SR-V10E-2Turn on all components Make connectionsLoad cassettes Start playback 26 EN Series RecordingPrepare for recording Start recording Set the input mode on both SR-V10EPress 7on either of SR-V10E Press 0on the SR-V10E which is recordingAccess the Showview Program screen Access the Showview screenBefore performing the Showview Timer Programming 28 ENAccess the Title Edit screen Set the VPS/PDC modeEngage the recorder’s timer mode Enter the programme title30 EN Express Timer ProgrammingVPS/PDC Recording To Timer-Record Weekly Or Daily SerialsEnter the channel position Press PR+Before performing the 24 Hour Express Timer Programming Enter the programme mode32 EN Set the programme start/stop time and channelDisengage the timer mode Cancel or change a programmeReturn to the timer mode Access the Programme Check screen/displayConfirm the overlapping programmes Cancel or change programme settingSelect the programme to modify Overlapping programmes blink on the TV screenProgramme Recording Recording modeBefore performing the following steps 36 EN NavigationNavigation Playback Access the Main Menu screenProgramme Navigation Screen Load a recorded cassetteEdit Programme Title 38 ENSelect the programme Delete Tape Data Entering CharacterDelete the tape data Example Enter JVC News40 EN Edit From a CamcorderAnother Video Recorder Set the input mode of recording deckAdvantages of S-VHS video recorders Start the source playerConnecting To a Satellite Receiver Make connections Connecting/Using a Stereo SystemAccess the Mode Set screen Mode SetSelect the mode Select the mode settingPowered back on Using this video recorder as the source player for editingPicture reproduction is also linked to this function We recommend that you set Digital TBC/NR to on when46 EN While timer-recording in SP modeScreen Set PROG. Navigation to OFFS-VHS recording mode is selected Correction to the luminance signal to enhance detailSetting Panel. Then, set S-VHS to OFF. The S-VHS indicator goes offAbout Ntsc Playback 48 ENAccess the Initial Set screen Showview System SetupGuide Program Number Set Guide Program NumberTuner Set Access the Auto Channel Set screen50 EN Auto Channel SetView the Confirmation screen Perform Auto Channel SetPress OK Manual Channel Set 52 ENChange Station Channel Position Delete a ChannelSelect the item Delete a channelSet Stations a 54 ENSet Stations B Station Name TV Station And ID ListClock Set Access the Clock Set screen56 EN Set Just Clock Set the date and timeSet the source channel position for clock data Start the clock operation58 EN Video Channel SetPower Recording 60 ENOther Problems Playback 62 ENScan system Signal-to-noise ratio 45 dB Horizontal resolutionLines VHS Lines S-VHS64 EN Memo 66 EN