EN 11
Scan Mode Set
(DVD deck)
This unit supports the progressive scan system (eg. 480p*) as well as the conventional interlaced scan system (eg. 480i*).
If your TV equipped with component video connectors supports the progressive video input, you can enjoy a high quality picture by setting the progressive scan mode to active.
●Refer also to the instruction manuals supplied with your TV.
●If your TV equipped with component video connectors does not support the progressive video input, do not change the scan mode to the “PROGRESSIVE.”
*480p and 480i indicate the number of scanning lines and scanning format of an image signal.
•480p indicates 480 scanning lines with progressive format.
•480i indicates 480 scanning lines with interlaced format.
●Turn on the TV and select the VCR channel (or AV mode).
●Slide the TV/VCR/DVD switch on the Remote to the right.
SCAN MODE
Slide to the right.
to the right.
DVD
A Turn on the unit.
Press 1.
B Select the DVD deck.
On the unit
Press VCR/DVD repeatedly so that the DVD indicator lights up.
On the Remote
Press DVD so that the DVD indicator lights up.
C Switch the mode.
APress and hold SCAN MODE on the unit for more than 3 seconds.
The current scan mode blinks on the front display panel.
BWhile the current scan mode blinks, press w e to select “ProGr” (for the progressive scan mode) or “IntEr” (for the interlaced scan mode), then press
ENTER.
•If the current scan mode stops blinking before you make the setting, start from step A again.
NOTE:
When the progressive scan mode is selected, the Progressive mode indicator () lights up on the front display panel.