14 EN | INITIAL SETTINGS (cont.) |
Auto Set Up
The Auto Set Up simplifies installation by guiding you through the procedures of setting the clock and tuner channels – simply follow the
Slide to the right.
Before starting, make sure of the following:
●The TV aerial cable should be connected to the unit.
●The unit’s mains power cord should be connected to a mains outlet.
●The “Video Channel Set“ ( pg. 13) should be performed
and the TV should be set to its AV mode (with AV connection pg. 9) or UHF channel (with RF connection pg. 9).
●Slide the TV/VCR/DVD switch on the remote control to the right.
A Turn on the unit.
Press 1 on the unit or remote control. The Language Select screen appears on the TV screen.
B Select language
Press rt to place the pointer next to your desired language (English, Russian or Arabic), then press ENTER or e.
●The Clock Set screen appears.
C Set the date and time.
Press rt to set the time, then press ENTER or e. The “DATE” display begins blinking. Repeat the same procedure to set the date and year.
●When you set the time/date,
press and hold rt to change the time by 30 minutes/15 days.
D Select the TV system.
Press rt to place the pointer next to the appropriate TV system (refer to the table below).
Major Countries/Areas | TV System |
|
|
Australia, New Zealand, Kuwait, | B/G |
U.A.E., Indonesia, Singapore, |
|
Thailand, Malaysia, Iran, Saudi Arabia, |
|
Egypt, Morocco, Lebanon, Iraq |
|
|
|
China, Mongolia, Russia | D/K |
|
|
Hong Kong | I |
|
|
E Start Auto Channel Set.
Press ENTER or e.
DO NOT press any button on the unit or remote control while Auto Set Up is in progress.
Auto Channel Set is performed next. Auto Channel Set scans all the channels that are receivable by your unit. During Auto Channel Set, the channel numbers are displayed as they are scanned and set.
● As Auto Set Up progresses, the |
|
|
“q” mark on the TV screen |
|
|
moves from left to right. |
| AUTO CH SET |
● When Auto Set Up is |
| PLEASE WAIT |
completed, the lowest position |
| |
|
| |
number will appear on the front |
|
|
display panel. If “SCAN | START | FINISH |
COMPLETED | ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ – – – – – – – | |
diplayed on the TV screen, make sure that the aerial cable
is connected to the unit properly and press ENTER on the remote control. The unit will try Auto Set Up again.
NOTES:
●If there is a power cut, or if you press 1 or SET UP while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to turn off the unit power once and try again from step A.
●If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Set Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
“TV System Selection — When you see the picture but the audio can’t be heard or sounds unnatural” pg. 63).
ATTENTION
If you perform Auto Set Up successfully during installation, there’s no need to separately perform the Clock Set or Channel Set procedures, but if adjustments become necessary, they can be performed as follows:
●Tuner setting pg. 60
●Clock setting pg. 19