JVC LPT0976-001B, 1204MNH-SW-VE manual Preset Download, Set/Auto Guide Programme Number Set

18 EN INITIAL SETTINGS

Preset Download		If you have connected the unit to your TV via a 21-pin SCART
		cable (A pg. 16), the unit will automatically perform Preset
Auto Channel Set by Downloading from TV/Auto Clock		Download instead of the Auto Set Up in step 4 on page 17. After
		downloading, the unit sets the clock and Guide Programme
Set/Auto Guide Programme Number Set		numbers automatically.
		● Slide the TV/CABLE/SAT/DVD switch to DVD.
ATTENTION:		● Perform steps 1 to 3 of AAuto Set UpB (A pg. 17) before
		continuing.
You can use this function only with a TV offering T-V Link, etc.*		1 Press DE to select AT-V LINKB
Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,		and press ENTER. The T-V	INITIAL SET UP > AUTO CH SET
SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART		LINK screen will appear.
cable. The degree of compatibility and available functions may differ by		● When T-V LINK is completed,		AUTO SET	T-V LINK
system.
		ASCAN COMPLETEDB appears
		on the TV screen. After selecting
CABLE/SAT		AOKB, APLEASE WAIT...B
TV	DVD	appears on the screen while	SET UP	ENTER SELECT WITH @ THEN PRESS [ENTER]
				PRESS [SET UP] TO EXIT
		channel data is being	EXIT	SELECT
		transferred to the VHS deck.	INITIAL SET UP > T-V LINK
		During this period
		(approximately 80 seconds), the
		VHS deck is not operable. It will		PLEASE WAIT...
				T-V LINK
		exit the T-V LINK mode once
		APLEASE WAIT...B disappears		CANCEL
		from the screen.	SET UP	ENTER SELECT WITH @ THEN PRESS [ENTER]
			EXIT	PRESS [SET UP] TO EXIT
ENTER				SELECT
we		ATTENTION:
		Preset positions on the front display panel increase from APR 1B;
		do NOT press any button on the unit or remote control until the
		front display panel shows clock time, APR 1B or A– –:– –Bas
		illustrated on page 19.
		● If you press any button on the unit or remote control while
		downloading is in progress, it will be interrupted.
		NOTES:
		● For details, refer to the instruction manual of your TV.
		● In the area where no TV station transmits a PDC (Programme
		Delivery Control) signal, the unit can perform neither Auto Clock
		Set nor Auto Guide Programme Number Set.
		● If there is a power cut, or if you press A or SET UP while
		downloading or set up is in progress, it will be interrupted; be
		sure to turn off the unit power once and try again from the
		beginning.
		● Auto Clock Set may not function properly depending on the
		reception condition.
		● On this unit, the characters available for station names (ID) are
		A–Z, 0–9, –, Z, + and & (space). Some names of downloaded
		stations may differ from those of your TV. (A pg. 85)
		After APreset DownloadB is completed, perform AMonitor SetB on
		page 21.