JVC 1204MNH-SW-VE Failure to heed the following precautions may result, Do not place the unit

Page 3

SAFETY FIRST 3

EN

 

 

MOISTURE CONDENSATION

For Italy:

 

Moisture in the air will condense on the unit when you move it from

AIt is declared that this product, brand JVC, conforms to the

 

 

a cold place to a warm place, or under extremely humid

Ministry Decree n. 548 of 28 Aug.’95 published in the Official

 

 

conditions^just as water droplets form on the surface of a glass

Gazette of the Italian Republic n. 301 of 28 Dec.’95B

 

 

filled with cold liquid. In conditions where condensation may occur,

 

 

 

 

 

disconnect the unit’s power plug from the wall and keep it

The STANDBY/ON A button does not completely shut off

 

disconnected for a few hours to let the moisture dry, then turn on

mains power from the unit, but switches operating current on

 

the unit.

and off. ABB shows electrical power standby and ACB shows ON.

 

 

 

ATTENTION:

 

 

 

When the equipment is installed in a cabinet or a shelf, make sure

 

To mobile phone users:

that it has sufficient space on all sides to allow for ventilation

 

Using a mobile phone in the vicinity of the unit may cause picture

(10 cm or more on both sides, on top and at the rear).

 

vibration on the TV screen or change the screen to a blue back

When discarding batteries, environmental problems must be

 

display.

 

On placing the unit:

considered and the local rules or laws governing the disposal of

 

these batteries must be followed strictly.

 

Some TVs or other appliances generate strong magnetic fields.

Failure to heed the following precautions may result in

 

Do not place such appliances on top of the unit as it may cause

 

picture disturbance.

damage to the unit, remote control or disc.

 

 

When moving the product:

1. DO NOT place the unit ^

 

^ in an environment prone to extreme temperatures or

 

Press A to turn off the power, and wait at least 30 seconds

humidity.

 

before unplugging the power cord. Then, wait at least 2 minutes

^ in direct sunlight.

 

before moving the product.

^ in a dusty environment.

 

 

 

 

^ in an environment where strong magnetic fields are

 

HOW TO USE THIS INSTRUCTION MANUAL

generated.

 

All major sections and subsections are listed in the Table Of

^ on a surface that is unstable or subject to vibration.

 

 

Contents on page 4. Use this when searching for information on

2. DO NOT block the unit’s ventilation openings or holes.

 

 

a specific procedure or feature.

(If the ventilation openings or holes are blocked by a

 

 

The Index on pages 10 – 13 illustrates the controls and

newspaper or cloth, etc., the heat may not be able to get out.)

 

 

connections on the front and rear panel, the front display panel

3. DO NOT place heavy objects on the unit or remote control.

 

 

and the remote control.

4. DO NOT place anything which might spill on top of the unit

 

 

The list of terms on page 99 lists frequently-used terms, and the

or remote control.

 

 

number of the page on which they are used or explained in the

(If water or liquid is allowed to enter this equipment, fire or

 

 

manual.

electric shock may be caused.)

 

 

The A mark signals a reference to another page for instructions

5. DO NOT expose the apparatus to dripping or splashing.

 

 

or related information.

6. DO NOT use this equipment in a bathroom or places with

 

 

Operation buttons necessary for the various procedures are

water. Also DO NOT place any containers filled with water or

 

 

clearly indicated through the use of illustrations at the beginning

liquids (such as cosmetics or medicines, flower vases, potted

 

 

of each major section.

plants, cups, etc.) on top of this unit.

 

 

 

7. DO NOT place any naked flame sources, such as lighted

 

 

candles, on the apparatus.

 

 

8. AVOID violent shocks to the unit during transport.

 

 

Image 3
Contents DR-MX1S Safety Precautions Do not place the unit Failure to heed the following precautions may resultDamage to the unit, remote control or disc Or remote controlContents After finalising About DiscsDVD-R/RW Discs Before finalisingDiscs For Playback Only Unplayable DiscsRegion Number DVD-R Recording Medium And FormatFile Structure Of Discs DVD-RAMDVD Video Marks Recording side Maintenance of discsCare And Handling Of Discs Label sideH I J Front ViewRear View Region Number Label a pg AC Power Cord a pg Cooling FanFront Display Panel HDD Button* a pg Remote ControlWhen pressing REC Mode Appears for eight seconds When pressing R during recordingPR.12 On-Screen Display VHS deck When capturing images from the external DV equipmentOperation Mode Indicators Tape Speed SP/LP On-Screen Display DV DubbingBasic Connection To connect to a TV with 21-pin Scart input connectorTo connect to TV’s component video input connectors When your TV’s Scart Set AL-1 Output B to Connector acceptsBefore starting, make sure of the following Auto Set UpSet/Auto Guide Programme Number Set Preset DownloadLink Functions On The Front Display PanelEnter LanguageLetter Box Monitor SetPan&Scan/Letter Box Pan&ScanHDD & DVD Deck Only Installing Satellite ControllerBrand Name Code Basic Playback Variable Speed Search Playback FeaturesJump Search Still Picture/Frame-By-Frame Playback Resume FunctionSlow Motion Skip SearchMarking Positions To Play Back Again Later Checking The Time InformationAngle Selection One Touch Replay Subtitle Selection Audio Language/Sound SelectionAudio Channel Selection Playback Control PBC FunctionRepeat Playback How To Access The On-screen BarContents of the on-screen bar during playback Basic Operation On The On-screen BarDVD-RAM/RW/R Adjusting The Picture Quality Time SearchSimulated Surround Effect Setting The Progressive Mode Random PlaybackProgramme Playback To change the level To Change The SettingsTo Set Parental Lock For The First Time To Temporarily Release Parental LockRecording Mode Elapsed Recording Time And Disc Remaining Time Indication Recording FeaturesInstant Timer Recording ITR Watch Another Programme While Recording On The UnitType of Broadcast Being Select AFR Justb in a recording mode selection procedureFree Rate Function Selection Of The Audio Channel To Be Recorded On a DiscBasic Recording Pause recording on HDD deckMemory Playback Watch Another Programme While Recording On The Unit Still Picture/Frame-By-Frame Playback Basic Playback Playback FeaturesMarking Positions To Play Back Again Later 5x Speed SearchTC-20 ST-C20 TC-30 ST-C30 TC-40 ST-C40 Usable cassettes Full-Size VHS30 ST-30 60 ST-60 120 ST-120 160 ST-160 ST-210 Compact VHSIndex Search VHS Progressive Scan Next Function MemoryManual Tracking Soundtrack SelectionElapsed Recording Time Indication Basic Recording Recording FeaturesTape Remaining Time S.T. Picture SystemLive Memory Playback Recording/playback Status DisplayPress R or Live to stop Live Memory Playback Live Available only when pausedJump Jump +RetroActive Recording HDD deck only Resuming Playback HDD deck onlyAbout limitation on temporary recording Satellite Receiver Users CTimer ProgrammingOnce One Time Recording Weekly Weekly Recording Weekly/Daily RecordingFor the HDD deck For the DVD deckRelief Recording Manual Timer ProgrammingCheck Programmes Cancel And Change ProgrammesHDD Deck Only RecordingProgramme BTimer ProgrammingVPS/PDC Recording Manual Timer ProgrammingTo change the programme setting When Programmes Overlap Each OtherCheck, Cancel And Change Programmes When the VHS lamp does not light up on the unitIcons and their meanings About registration of informationLimitations of registration EditScan For Beginning Of Title Edit Original Information Modify IndexModify Title Name Delete Title RAM & DVD-RWVR mode onlyModify Category Unwanted Part Of The Title Protect Title DVDPlay List Modify Chapter HDD, DVD-RAM & DVD-RW VR mode onlyEdit Play List Information Divide Title HDD deck onlyMove Scenes Create Play ListEdit Scenes Add scenesEdit Library Information ENTER. The unit starts Desired group, then pressList of files in the selected Group appearsManual Dubbing From HDD To DVD DubbingJust Dubbing From HDD To DVD High Speed Dubbing From HDD To DVDOriginal Dubbing From DVD To HDD Dubbing From HDD To VHSDubbing From VHS To DVD Dubbing An Entire Cassette Dubbing From VHS To HDDDubbing An Entire Cassette Dubbing From VHS To HDD Dubbing a Programme From CassetteAbout Disc Remaining Display When performing the Just DubbingWhen performing the Manual Dubbing Dubbing From VHS To DVDRemote control switch Sound monitor switchAuto capture button To skip unwanted part of the source picture When you dub from DV equipment other than a camcorderEdit From a Camcorder If the camcorder has no S-VIDEO output connectorWhen using your unit as the source player When using your unit as the recording deckFor HDD/DVD deck Output And L-1 Input Setting Select SettingOutput/Input Set Input Setting Digital Audio DubbingExample Dubbing to an MD Keep pressing SET UP down during step Remote Control FunctionsRemote Control 1/2/3/4 Code Switching TV Multi-Brand Remote ControlSlide the TV/CABLE/SAT/DVD switch to CABLE/SAT Perfect Connections Recommended Has two 21-pin AV input Scart connectorsPin AV input Scart connector IN/DECODER connector to the satellite receiver’s connectorConnecting/Using a Decoder When you can’t switch the audio channel of a bilingualProgramme Mode Set Select this to dub the sub channel To record PAL signalsTo record Secam signals or a Mesecam tape Select this to dub the main channelTo turn off superimposed indications You can change the brightness of the front display panelNormally select this VHS Deck Only To lock tray Tray Lock DVD Deck OnlyFor Example About Ntsc PlaybackAuto Channel Set CSystem SetupTuner Set Guide Programme Number SetManual Channel Set Change Station Channel Position When Receiving a Scrambled Broadcast HDD & DVD Deck OnlyFine-Tuning Channels Already Stored Delete a ChannelJust Clock Clock SetFormat a Disc DVD Deck Only Format a DVD-RAM DiscFormat a DVD-RWDisc Cancel The Finalisation Of a DVD-RWDisc After finalising For DVD-R/RW Video mode discsFinalise a DVD-R/RW Disc Scan mode via component video Watch the images on VHS deck in the ProgressivePress Progressive Scan Playback HDD Deck Playback DVD DeckInitialising DVD Deck Only GeneralRecording HDD Deck Timer Recording HDD & DVD DeckPlayback VHS Deck Recording DVD DeckFor component video connection Other ProblemsTimer Recording VHS Deck For basic connectionAn invalid anumber has been input. a pg Timer recording has finished during Live Memory playbackOn-screen Message HDD & DVD Deck Only During Live Memory playback, o has been pressed. a pgDimensions WxHxD Power requirementPower consumption TemperatureLanguage Code List Country/Area Code List for Parental Lock Appendix EN Station Name TV Station And ID ListAudio Language/Sound Selection Cancel And Change ProgrammesInstant Timer Recording ITR When Programmes Overlap Each OtherDR-MX1S