JVC LPT0976-001B manual Edit From a Camcorder, If the camcorder has no S-VIDEO output connector

70 EN EDITING

Edit From A Camcorder		● Slide the TV/CABLE/SAT/DVD switch to DVD.
You can use a camcorder as the source player and your unit as the		1 Make connections.
		A If the camcorder has no S-VIDEO output connector:
recording deck.
		^ connect the camcorder’s AUDIO/VIDEO OUT connectors to
A If the camcorder has no S-VIDEO output connector:		the unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors
		on the front panel.
		● When using a monaural camcorder, connect its AUDIO OUT
		connector to the [AUDIO-L] input connector on your unit.
		B If the camcorder has an S-VIDEO output connector: (HDD &
		DVD deck only)
		^ connect the camcorder’s AUDIO OUT and S-VIDEO OUT
To [VIDEO/AUDIO	Recorder	connectors to the unit’s [AUDIO] and [S-VIDEO] input
((MONO) L/R)] input		connectors on the front panel.
		2 Press VHS/HDD/DVD SELECT on the unit repeatedly to select
Audio/video cable		the recording deck.
		3 Press PR +/– to select AF-1B.
(not supplied)

● Set AF-1 INPUTB to AVIDEOB for the [AUDIO] input connector, or AS-VIDEOBfor the [S-VIDEO] input connector, depending on the connector being used. (A pg. 73)

Player

AUDIO/VIDEO OUT

BIf the camcorder has an S-VIDEO output connector (HDD & DVD deck only):

To [S-VIDEO]	To [AUDIO] input	Recorder
input

	Audio cable
S-video cable	(not
(not supplied)	supplied)

4Press REC MODE repeatedly to set the recording mode.

5Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.

6Press R on the unit to start recording. Or while holding R, press I on the remote control. The dubbing starts.

7Press o on the unit, then stop playback on the camcorder.

NOTES:

●All necessary cables can be obtained from your dealer.

●Refer to the camcorder’s instruction manual for operating procedure.

●The quality of dubbed picture becomes poorer than that of the original.

Player

S-VIDEO OUT

AUDIO OUT