SAT CONTROL SET EN 23
12 Check the result of the test.
If the satellite receiver’s channel number has been changed to the same one as you set in step 10
Press DE to select AYESB, then press ENTER to finish the Sat
Control Set mode.
If the satellite receiver’s channel number has not been changed correctly
Press DE to select ANOB, then press ENTER. Then perform the procedure again from step 7.
BRAND NAME | CODE |
|
|
JVC | 73 |
AMSTRAD | 60, 61, 62, 63, 92 |
ASTON | 97 |
CANAL SATELLITE | 81 |
CANAL + | 81 |
85 | |
ECHOSTAR (VIA DIGITAL) | 82 |
FINLUX | 68 |
FORCE | 89 |
GALAXIS | 88 |
GRUNDIG | 64, 65, 102 |
HIRSCHMANN | 64, 78, 99 |
HUMAX | 88 |
ITT NOKIA | 68 |
JERROLD | 75 |
KATHREIN | 70, 71, 96 |
LUXOR | 68 |
MASCOM | 93 |
MASPRO | 70 |
NOKIA | 87, 94 |
PACE | 65, 67, 74, 86, 92, 97 |
PANASONIC | 74, 92 |
PHILIPS | 66, 84, 101 |
RADIX | 78 |
RFT | 69 |
SABA | 97 |
SAGEM | 83, 90 |
SALORA | 68 |
SAMSUNG | 83 |
SIEMENS | 64 |
SKYMASTER | 69, 98 |
TECHNISAT | 66, 100 |
THOMSON | 97 |
TPS | 83 |
TRIAX | 91 |
WISI | 64 |
|
|
NOTES:
●The Satellite Controller may not work with all types of satellite receiver.
●For some satellite receivers, you need to set its channel input mode to
●If your satellite receiver has more than two channel modes, be sure to set to AAll Channel ModeB. For details, refer to the instruction manual of the satellite receiver.
●When selecting the satellite receiver’s channel (A step 10), signals from the remote control may interfere with signals transmitted from the Satellite Controller. In this case, move the remote control as close to the unit’s infrared beam receiving window as possible.