Dish Network 138410, Solo 811 quick start Remote Control, Telephone Jack

Telephone Jack

Connect a telephone cable with a standard RJ-11 telephone connector to the receiver here, and then connect the cable to an active telephone line.

Note: The receiver must be connected at all times to an active telephone line.

The Remote Control

The remote control gives you easy access to all of the features of your satellite receiver. You can set up the remote to control the satellite receiver, TV, VCR and any other one piece of A/V equipment such as a DVD player and home theater equipment.

If you are installing or re-installing your receiver, you will need to follow the setup procedures in this chapter.

Complete instructions on how to use the remote, as well as the rest of the system, are in Chapter 3.

Note: The remote control shown here is for example only. Your remote control may be different.

The Remote Control

Tip: If you have the receiver connected to a DSL (Digital Subscriber Line) phone line and it cannot dial out, you may have to install a DSL filter between the receiver and the telephone jack on the wall.

Page 15