Chapter 3
Using the System
Instructions | Additional Information |
11If you can’t find a code that works try, Setting Up Using Device Codes Scan that fol- lows.
Scan for Device Codes
If the code for your device is not listed in the device codes on page 86, use this procedure to scan the remote control’s memory for the device code. In the following instructions, the column on the left contains the instructions and the column on the right provides additional information.
Instructions | Additional Information |
|
|
1. Turn the device on. | Use the device’s front panel buttons |
| or its remote control. |
2.Press and hold the mode button until all the other mode buttons light up, and then let go of the button.
The mode button flashes.
3.For AUX mode only. Press 0 for a second TV, or 1 for a VCR or DVD player, or 2 for a tuner, or amplifier. Press the STAR (*) button.
4.Press the POWER button.
For example, hold the TV mode button for a TV until all of the other mode buttons light. When you let go, the TV mode light will flash.
This step is for programming which kind of device that should be programmed in AUX mode. If you’re not programming in AUX mode, skip to step 4.
This puts your remote in the scan mode.
5.Press the either the UP or
DOWN ARROW button repeatedly until the device turns off.
6.Press the POUND (#) button.
As you press the UP or DOWN ARROW button, the remote is trying each code in the memory to see if it can turn off your device. When the device turns off, you have found a code that might work.
Note The mode button for the device will flash rapidly eight times when you’ve scanned all the codes for that device.
This stores the code you found.
Page 66