Sat measurement
Tracking Satellites
The "SCAN" function can search for satellites whose exact transponder frequencies are unknown. The frequency range from 1000 to 2100 MHz is scanned continuously to detect signals. If signals are received, the reception level is indicated in a bar display. The measuring range can be set to three different sensitivity levels.
The level can be monitored with an audio tracking signal, the volume being proportional to the level of the signal received. The volume of the audio tracking signal can be set with the volume control.
Overview of commands in SCAN
ë | [2ndF] [SCAN] Switch over to SCAN operation. | ||
Change the measuring range of the bar display. | |||
| |||
Level range 1: high input level
Level range 2: medium input level
Level range 3: low input level
Exit SCAN by pressing [2ndF] twice.
LC display:
Example
0
∙Level range 2: medium input level
∙SAT mode
∙Bar display
Calling up the SCAN function
•Press the [2ndF] and [SCAN] buttons.
•Rotate the antenna until a level tendency is visible on the bar display.
•Rotate the antenna until the bar display has reached its maximum.
•If necessary, decrease or increase the sensitivity with the
Exit SCAN by pressing [2ndF] twice.
21