Kathrein MSK 24 manual LEV-RANGE2 TV Example, Press buttons 2ndF Level

Page 38

TV measurement

Tracking for Single Frequencies

In the "LEVEL " function you can align an antenna by tracking to receive the maximum signal. The level tendency can be indicated in the bar display. The measuring range can be set to three different sensitivity levels.

The level can be monitored with an audio tracking signal, the volume being proportional to the level of the signal received. The volume of the audio tracking signal can be set with the volume control.

Overview of commands in Tracking

ë	[2ndF] [LEVEL ] Switch over to the tracking mode
	[-] [+]	Switch	among	the measuring ranges of the bar
		display.	The	measuring range is automatically
		preselected.
		Level range 1:		high input level
		Level range 2:		medium input level
		Level range 3:		low input level

Exit the LEVEL mode by pressing [2ndF] twice.

LC display:

LEV-RANGE:2 TV >

Example

∙Level range 2: medium input level

∙Mode: TV

∙Bar display

Call up the "LEVEL " function:

0	Press buttons [2ndF] [LEVEL ].
	Rotate the antenna until the bar display has reached its maximum.

If necessary, decrease or increase the sensitivity with the [-]and [+] buttons.

Repeat this procedure until you have reached the maximum level.

Exit the LEVEL menu by pressing [2ndF] twice.

38

Image 38

Contents Satellite / TV / Radio Test Receiver MSK Page Preface Validity of this manualContents Spectrum measurement Technical AppendixGeneral Notes Explanation of symbolsSafety instructions Parts suppliedHow it operates Overview of functions Block diagram of MSK Technical Data SAT10 V...20 V, max mA Connections right side Operating and display elementsDisplay elements LC displayOverview of the keyboard commands External DC voltage supply ConnectionsRF input socket Scart outputStarting up Switching on the receiverSwitching off the receiver Software Accu LEV 48.5dBuVSettings in the setup menu Setup menuFactory settings Setup menuMains operation Mains and battery operationBattery operation Press 2ndF STD Standard Switch-OverSat measurement Press 1 5 0 8 E Nter Overview of commands in Entering Frequency SATFrequency Display and Entering Frequency LEV .dBuV Level MeasurementLevel Overflow and Underflow LEV dBuVChange the measuring range of the bar display 2ndF Scan Switch over to Scan operationTracking Satellites Calling up the Scan functionOverview of commands in Tracking Tracking for Single FrequenciesPress 2ndF SC Audio Carrier FrequencyButton Frequency in MHz Bandwidth in kHz LNB voltage Button LNB Voltage and 22 kHz / 60 Hz Switch-OverOverview of commands in LNB Voltage Example LNB14,0V 150mA Press buttons 2ndF LNBExample LNB14,0V 22kHz 150mA DiSEqC Digital Satellite Equipment Control Parity bitOverview of commands in Framing Byte Press buttons 2ndF SAT-CTRLOverview of commands in Address Byte Hex byte DescriptionOverview of commands in Command Byte Sat measurement Overview of commands in Simple DiSEqC Overview of commands in Data ByteOrbit Switch position Data Position Simple Tone Burst DiSEqCDiSEqC-SIMPLE Tone Burst Enter the figures 0 to SEC Vario-Satellite Equipment Control2ndF SAT-CTRL Call up the V-SEC menu Enter the letters A...F Button=BG 2=L 3=DK =I 5=MN 6=M1 Overview of commands in Standard Switch-Over TVTV measurement Channel Display and Entering Channel Switch over to TV receptionSwitch to special channel Enter the channelThen 1 7 5 ./S 2 5 Enter Level Measurement TV LEV.dBuVLEV-RANGE2 TV Example Press buttons 2ndF LevelStandard Audio carrier Nicam Overview of commands in Measuring Audio Carrier FrequencyAudio Carrier Distance and Level SC 5.50MHz LEV -13.0dB LEV 58.5dBuVSC 5.85 MHz BER=2.145E-05 Nicam Measuring Audio Bit Error RatesCalling up Measuring Audio Bit Error Rates Press 2ndF FM FM measurement2ndF FM Then 9 9 ./S 2 5 EnterFR104,80MHz FM LEV¯¯¯.¯dBuV TV Spectrum Spectrum measurementSat Spectrum SAT-FullTV full Overview of commands in TV SpectrumFM Spectrum TV narrowCustomer service MaintenanceChanging the battery +14.1 dB Signal-to-noise distanceTechnical Appendix Command set for Kathrein matrix EXR DiSEqC commands for Kathrein matricesCommand set for Kathrein matrix 9xx-series Channel tables VHF-CCIR UHF-CCIRChannel and frequency table for L standard frequency in MHz VHF UHFIII Channel and frequency table for I standard frequency in MHz Technical Appendix Technical Appendix Technical Appendix Page 936.1997/ZWT/PF Technical data subject to change