Kathrein MSK 24 manual Frequency Display and Entering Frequency, Then 1 7 5 ./S 2 5 Enter

Page 36

TV measurement

Frequency Display and Entering Frequency

To measure the level of a received TV signal, you must first enter the desired video carrier frequency.

You can enter the frequency in steps of 50 kHz from 45 MHz to 867 MHz.

Overview of commands in Entering Frequency (TV)

ë

Example

0

CH:175,25TV LEV: 65,0dBuV

Note

+

[SAT/TV]

Switch over to TV reception

[CH-FRQ]

Switch-over between channel and frequency

[0]...[9]

Enter frequency

[ENTER]

Confirm entry

[+]and [-]Change frequency gradually

Enter frequency of 175.25 MHz:

 

Press [2ndF] [CH/FRQ]

..(Call up the frequency menus)

Then [1] [7] [5] [./S] [2] [5] [ENTER] ..

.(Entering frequency)

LC display:

Frequency: 175.25 MHz

Level: 65.0 dBìV

Mode: TV

Once you have called up the frequency menu, you only need to enter the figures to enter the frequency again.

The last frequency setting is retained even when the MSK 24 is switched off provided it was made using "numerical entries" and concluded with "MHz".

36

Image 36
Contents Satellite / TV / Radio Test Receiver MSK Page Preface Validity of this manualContents Spectrum measurement Technical AppendixExplanation of symbols Safety instructionsGeneral Notes Parts suppliedHow it operates Overview of functions Block diagram of MSK Technical Data SAT10 V...20 V, max mA Operating and display elements Display elementsConnections right side LC displayOverview of the keyboard commands Connections RF input socketExternal DC voltage supply Scart outputSwitching on the receiver Switching off the receiverStarting up Software Accu LEV 48.5dBuVSetup menu Factory settingsSettings in the setup menu Setup menuMains and battery operation Battery operationMains operation Standard Switch-Over Sat measurementPress 2ndF STD Overview of commands in Entering Frequency SAT Frequency Display and Entering FrequencyPress 1 5 0 8 E Nter Level Measurement Level Overflow and UnderflowLEV .dBuV LEV dBuV2ndF Scan Switch over to Scan operation Tracking SatellitesChange the measuring range of the bar display Calling up the Scan functionOverview of commands in Tracking Tracking for Single FrequenciesAudio Carrier Frequency Button Frequency in MHz Bandwidth in kHzPress 2ndF SC LNB Voltage and 22 kHz / 60 Hz Switch-Over Overview of commands in LNB Voltage Example LNB14,0V 150mALNB voltage Button Press buttons 2ndF LNBExample LNB14,0V 22kHz 150mA DiSEqC Digital Satellite Equipment Control Parity bitOverview of commands in Framing Byte Press buttons 2ndF SAT-CTRLOverview of commands in Address Byte Hex byte DescriptionOverview of commands in Command Byte Sat measurement Overview of commands in Data Byte Orbit Switch position Data PositionOverview of commands in Simple DiSEqC Simple Tone Burst DiSEqCDiSEqC-SIMPLE Tone Burst SEC Vario-Satellite Equipment Control 2ndF SAT-CTRL Call up the V-SEC menuEnter the figures 0 to Enter the letters A...F ButtonOverview of commands in Standard Switch-Over TV TV measurement=BG 2=L 3=DK =I 5=MN 6=M1 Switch over to TV reception Switch to special channelChannel Display and Entering Channel Enter the channelThen 1 7 5 ./S 2 5 Enter Level Measurement TV LEV.dBuVLEV-RANGE2 TV Example Press buttons 2ndF LevelOverview of commands in Measuring Audio Carrier Frequency Audio Carrier Distance and LevelStandard Audio carrier Nicam SC 5.50MHz LEV -13.0dB LEV 58.5dBuVNicam Measuring Audio Bit Error Rates Calling up Measuring Audio Bit Error RatesSC 5.85 MHz BER=2.145E-05 FM measurement 2ndF FMPress 2ndF FM Then 9 9 ./S 2 5 EnterFR104,80MHz FM LEV¯¯¯.¯dBuV Spectrum measurement Sat SpectrumTV Spectrum SAT-FullOverview of commands in TV Spectrum FM SpectrumTV full TV narrowMaintenance Changing the batteryCustomer service Signal-to-noise distance Technical Appendix+14.1 dB DiSEqC commands for Kathrein matrices Command set for Kathrein matrix 9xx-seriesCommand set for Kathrein matrix EXR Channel tables VHF-CCIR UHF-CCIRChannel and frequency table for L standard frequency in MHz VHF UHFIII Channel and frequency table for I standard frequency in MHz Technical Appendix Technical Appendix Technical Appendix Page 936.1997/ZWT/PF Technical data subject to change