Kathrein MSK 24 Channel Display and Entering Channel, Switch over to TV reception, Press ./S 1

TV measurement

Channel Display and Entering Channel

To measure the level of a received TV signal, you must first enter the desired channel.

The following channels can be set:

∙Band I / III CH 01 to CH 12 in the 7 MHz raster

∙Band IV / V CH 21 to CH 70 in the 8 MHz raster

∙	Special channel	S 01 to S 20 in the 7 MHz raster
∙	Special channel	S 21 to S 41 in the 8 MHz raster

The information refers only to the factory-preset B/G standard. You can find information for other standards in the Technical Appendix.

Overview of commands in Entering Channel (TV)

ë

Example

0

CH:S.11.TV LEV: 62.5dBuV

Note

+

[SAT/TV]	Switch over to TV reception
[0]...[9]	Enter the channel
[./S]	Switch to special channel

[+]and [-]Alter the channels gradually

Enter channel S11:

Press [./S] [1] [1].

LC display:

∙Special channel: S 11

∙Level: 62.5 dBìV

∙Mode: TV

Make sure that the correct standard has been set. The B/G standard is the default setting.

35