Kathrein cap910 manual Mobiset 4 CAP 910 Components / Scope of Delivery, Product Package

Page 3

MOBISET 4 CAP 910 COMPONENTS / SCOPE OF DELIVERY

75 cm satellite dish

Twin LNB

Turntable with integral controls and GPS receiver

UFS 940sw (Front view)

See the UFS 940sw operating manual for a rear view of the receiver together with explanation of functions and operating instructions.

PRODUCT PACKAGE

The MobiSet 4 digital CAP 910 consists of:

•Turntable complete with control electronics (and GPS receiver), pre-assembled satellite dish and twin LNB

•Mounting plate

•Complete cabling set: 2 x coax cables each 8 m long, and one power supply cable (10 m) for connection to the on-board power supply

•Roof gland with sealing gasket

•Sikaﬂex® 291 adhesive sealant (100 ml tube)

•UFS 940sw HDTV-DVB-S receiver with connecting cables, infrared sensor and infrared remote control

•MobiSet 4 digital CAP 910 installation manual

•UFS 940sw satellite receiver operating manual

3

Image 3

Contents CAP Company Address and Accredited Representative GeneralProduct Package Mobiset 4 CAP 910 Components / Scope of DeliveryContents Installation Manual Contents Operating Manual Proper USE USE for the Intended Purpose Proper USESafety Instructions Important Notes Essential informationAdhesive sealant Road Trafﬁc Licensing Regulations StVZO Power supply, fusingChecks before commencing a journey Unpacking and Preparation Installation and ConnectionSelecting the Installation Location Required Tools and EquipmentDirection of travel Installation Steps Figure C Not included Variant with Cable Gland Underneath the Turntable Installation of TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Selection of a Suitable Installation Location Installation of the UFS 940SWPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Receiver. There is no restriction on Connection Example for 12 V Battery ConnectionReception Range / Footprint ESC Address of the Service CentreDismantling for Servicing DismantlingManual Lowering to Park Position Safety InstructionsManual Lowering Direction of travel Technical SpecificationsPotential hazards Sikaflex 291 Safety Data SheetMaterials/preparation and company designation Composition/data on componentsExposure limitation and personal protective equipment Measures for ﬁre ﬁghtingMeasures if inadvertently released Handling and storageStability and reactivity Physical and chemical characteristicsTransport data Toxicology data SensitisationEcological data Disposal instructionsOther data Sikaﬂex-291 Ikaflex Sikaflex 291 Technical Data SheetChemical Stability CAP 910 Operating Manual CAPRemote Control Important Information for CAP 910 Before SetupFirst Installation Hdmi Video System Automatic clock change summer/winter time Local time offset UTCAll satellite positions found by a search will be deleted CAP Menu Turntable Antenna SettingsResetting the CAP System Turntable Antenna Reset Calling UP the CAP MenuInputting the CAP GPS Position To Move the Antenna ManuallyElevation Stop on Signal LNB TILT/SKEWMove to the Azimuth Rotate the Antenna Search Speed CAP SettingsMove CAP to Park Position Elevation Border and Elevation OffsetCountdown for the Search Start Restore Factory SettingsAlignment Satellite Search Channel Selection from the Channel List Channel Satellite SELECTION/PROGRAMMING the TimerChannel Selection from the Channel List Sorted by Satellite Timer ProgrammingChange of Location Change of Location Parking the Turntable ParkSystem Protection Messages Special Messages from the TurntableSpecial Messages from the Turntable Further Messages Messages Arising from Software ProblemsTimer function is currently not yet available in CAP mode Declaration of Conformity Spent batteries are special waste Disposal Instructions