Kathrein cap910 manual Messages Arising from Software Problems, Further Messages

Page 57

SPECIAL MESSAGES FROM THE TURNTABLE

MESSAGES ARISING FROM SOFTWARE PROBLEMS

A serious software error has occurred. Reset the turntable in the CAP menu, or contact our service centre.

The turntable antenna software is defective. An update is required. Contact our service centre.

FURTHER MESSAGES

This message may also appear if:

-the ignition is switched on

-voltage is present at the ignition cable (green)

The receiver has lost communication with the turntable. Check the connection between the UFS 940sw and the turntable, the power supply and whether possibly the ignition signal is present at the CAP.

The connection to the turntable is defective. Reset the turntable in the CAP menu, check the connections between the turntable and receiver, or contact our service centre.

57

Image 57

Contents CAP Company Address and Accredited Representative GeneralProduct Package Mobiset 4 CAP 910 Components / Scope of DeliveryContents Installation Manual Contents Operating Manual Proper USE USE for the Intended Purpose Proper USESafety Instructions Important Notes Essential informationAdhesive sealant Road Trafﬁc Licensing Regulations StVZO Power supply, fusingChecks before commencing a journey Selecting the Installation Location Installation and ConnectionRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Figure C Not included Variant with Cable Gland Underneath the Turntable Installation of TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Selection of a Suitable Installation Location Installation of the UFS 940SWPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Receiver. There is no restriction on Connection Example for 12 V Battery ConnectionReception Range / Footprint Dismantling for Servicing Address of the Service CentreDismantling ESCManual Lowering to Park Position Safety InstructionsManual Lowering Direction of travel Technical SpecificationsMaterials/preparation and company designation Sikaflex 291 Safety Data SheetComposition/data on components Potential hazardsMeasures if inadvertently released Measures for ﬁre ﬁghtingHandling and storage Exposure limitation and personal protective equipmentStability and reactivity Physical and chemical characteristicsEcological data Toxicology data SensitisationDisposal instructions Transport dataOther data Sikaﬂex-291 Ikaflex Sikaflex 291 Technical Data SheetChemical Stability CAP 910 Operating Manual CAPRemote Control Important Information for CAP 910 Before SetupFirst Installation Hdmi Video System Automatic clock change summer/winter time Local time offset UTCResetting the CAP System Turntable Antenna Reset CAP Menu Turntable Antenna SettingsCalling UP the CAP Menu All satellite positions found by a search will be deletedInputting the CAP GPS Position To Move the Antenna ManuallyElevation Stop on Signal LNB TILT/SKEWMove to the Azimuth Rotate the Antenna Move CAP to Park Position CAP SettingsElevation Border and Elevation Offset Search SpeedCountdown for the Search Start Restore Factory SettingsAlignment Satellite Search Channel Selection from the Channel List Channel Satellite SELECTION/PROGRAMMING the TimerChannel Selection from the Channel List Sorted by Satellite Timer ProgrammingChange of Location Change of Location Parking the Turntable ParkSystem Protection Messages Special Messages from the TurntableSpecial Messages from the Turntable Further Messages Messages Arising from Software ProblemsTimer function is currently not yet available in CAP mode Declaration of Conformity Spent batteries are special waste Disposal Instructions