Kathrein cap910 manual Contents Operating Manual

Page 5

CONTENTS (OPERATING MANUAL)
CAP 910 OPERATING MANUAL	38
IMPORTANT INFORMATION FOR CAP 910 BEFORE SETUP	39
REMOTE CONTROL	39
FIRST INSTALLATION	40
CAP MENU (TURNTABLE ANTENNA SETTINGS)	44
CALLING UP THE CAP MENU	44
RESETTING THE CAP SYSTEM (TURNTABLE ANTENNA) (RESET)	44
INPUTTING THE CAP GPS POSITION	45
TO MOVE THE ANTENNA MANUALLY	45
ELEVATION	45
LNB TILT/SKEW	46
STOP ON SIGNAL	46
MOVE TO THE AZIMUTH (ROTATE THE ANTENNA)	46
MOVE CAP TO PARK POSITION	47
CAP SETTINGS	47
ELEVATION BORDER AND ELEVATION OFFSET	47
SEARCH SPEED	47
COUNTDOWN FOR THE SEARCH START	48
RESTORE FACTORY SETTINGS	48
ALIGNMENT (SATELLITE SEARCH)	49
CHANNEL (SATELLITE) SELECTION/PROGRAMMING THE TIMER	50
CHANNEL SELECTION FROM THE CHANNEL LIST	50
CHANNEL SELECTION FROM THE CHANNEL LIST (SORTED BY SATELLITE)	51
CHANGE OF LOCATION	52
PARK	54
PARKING THE TURNTABLE	54
SPECIAL MESSAGES FROM THE TURNTABLE	55
DECLARATION OF CONFORMITY	59
DISPOSAL INSTRUCTIONS	60

5

Image 5

Contents CAP Company Address and Accredited Representative GeneralProduct Package Mobiset 4 CAP 910 Components / Scope of DeliveryContents Installation Manual Contents Operating Manual Proper USE USE for the Intended Purpose Proper USEAdhesive sealant Safety Instructions Important NotesEssential information Road Trafﬁc Licensing Regulations StVZO Power supply, fusingChecks before commencing a journey Selecting the Installation Location Installation and ConnectionRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Figure C Not included Variant with Cable Gland Underneath the Turntable Installation of TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Selection of a Suitable Installation Location Installation of the UFS 940SWPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Receiver. There is no restriction on Connection Example for 12 V Battery ConnectionReception Range / Footprint Dismantling for Servicing Address of the Service CentreDismantling ESCManual Lowering to Park Position Safety InstructionsManual Lowering Direction of travel Technical SpecificationsMaterials/preparation and company designation Sikaflex 291 Safety Data SheetComposition/data on components Potential hazardsMeasures if inadvertently released Measures for ﬁre ﬁghtingHandling and storage Exposure limitation and personal protective equipmentStability and reactivity Physical and chemical characteristicsEcological data Toxicology data SensitisationDisposal instructions Transport dataOther data Sikaﬂex-291 Ikaflex Sikaflex 291 Technical Data SheetChemical Stability CAP 910 Operating Manual CAPRemote Control Important Information for CAP 910 Before SetupFirst Installation Hdmi Video System Automatic clock change summer/winter time Local time offset UTCResetting the CAP System Turntable Antenna Reset CAP Menu Turntable Antenna SettingsCalling UP the CAP Menu All satellite positions found by a search will be deletedElevation Inputting the CAP GPS PositionTo Move the Antenna Manually Move to the Azimuth Rotate the Antenna Stop on SignalLNB TILT/SKEW Move CAP to Park Position CAP SettingsElevation Border and Elevation Offset Search SpeedCountdown for the Search Start Restore Factory SettingsAlignment Satellite Search Channel Selection from the Channel List Channel Satellite SELECTION/PROGRAMMING the TimerChannel Selection from the Channel List Sorted by Satellite Timer ProgrammingChange of Location Change of Location Parking the Turntable ParkSystem Protection Messages Special Messages from the TurntableSpecial Messages from the Turntable Further Messages Messages Arising from Software ProblemsTimer function is currently not yet available in CAP mode Declaration of Conformity Spent batteries are special waste Disposal Instructions