Kathrein cap910 manual Technical Specifications, Direction of travel

Page 30

TECHNICAL SPECIFICATIONS

Direction of travel

Type		CAP 910
Order no.		20310022

LNB		2 switchable outputs:
LNB		V/H (14/18 V), low/high (0/22 kHz)
		V/H (14/18 V), low/high (0/22 kHz)
LNB supply voltage	V	vertical: 11.5-14, horizontal: 16-19

Input frequency	GHz	10.70-12.75

Output frequency	MHz	950-1950/1100-2150

Oscillator frequency (L.O.)	GHz	9.75/10.60

System quality (G/T) 11.3/12.5 GHz	dB/K	16.9/17.9

Power supply (vehicle battery)	V	10.9-13.8

Power consumption from the 12 V vehicle electrical system:
Inrush current/satellite search/TV-reception/stand-by	A	Type 10, max. 12/type 3/type 1.2/type 0.024
Current consumption from the receiver	mA	Type 200

Setting range: Elevation/azimuth/skew	°	3-67/390/± 45

Weight (without receiver)	kg	18.9

Packing unit/weight	Units/kg	1/22

30

Image 30

Contents CAP General Company Address and Accredited RepresentativeMobiset 4 CAP 910 Components / Scope of Delivery Product PackageContents Installation Manual Contents Operating Manual Proper USE Proper USE USE for the Intended PurposeSafety Instructions Important Notes Essential informationAdhesive sealant Power supply, fusing Road Trafﬁc Licensing Regulations StVZOChecks before commencing a journey Required Tools and Equipment Installation and ConnectionSelecting the Installation Location Unpacking and PreparationDirection of travel Installation Steps Figure C Not included Installation of Turntable Variant with Cable Gland Underneath the TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Installation of the UFS 940SW Selection of a Suitable Installation LocationPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Connection Example for 12 V Battery Connection Receiver. There is no restriction onReception Range / Footprint Dismantling Address of the Service CentreDismantling for Servicing ESCSafety Instructions Manual Lowering to Park PositionManual Lowering Technical Specifications Direction of travelComposition/data on components Sikaflex 291 Safety Data SheetMaterials/preparation and company designation Potential hazardsHandling and storage Measures for ﬁre ﬁghtingMeasures if inadvertently released Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityDisposal instructions Toxicology data SensitisationEcological data Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaﬂex-291 IkaflexChemical Stability CAP CAP 910 Operating ManualImportant Information for CAP 910 Before Setup Remote ControlFirst Installation Hdmi Video System Local time offset UTC Automatic clock change summer/winter timeCalling UP the CAP Menu CAP Menu Turntable Antenna SettingsResetting the CAP System Turntable Antenna Reset All satellite positions found by a search will be deletedInputting the CAP GPS Position To Move the Antenna ManuallyElevation Stop on Signal LNB TILT/SKEWMove to the Azimuth Rotate the Antenna Elevation Border and Elevation Offset CAP SettingsMove CAP to Park Position Search SpeedRestore Factory Settings Countdown for the Search StartAlignment Satellite Search Channel Satellite SELECTION/PROGRAMMING the Timer Channel Selection from the Channel ListTimer Programming Channel Selection from the Channel List Sorted by SatelliteChange of Location Change of Location Park Parking the TurntableSpecial Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further MessagesTimer function is currently not yet available in CAP mode Declaration of Conformity Disposal Instructions Spent batteries are special waste