Kathrein cap910 manual Measures for fire fighting, Measures if inadvertently released

Page 32

SIKAFLEX® 291 SAFETY DATA SHEET

5. Measures for fire fighting

Suitable extinguishing media

Compatible with all extinguishing media in general use. Special hazard from the product, its products of combustion or gases released

In case of fire the following can be released: Carbon monoxide (CO) Carbon dioxide (CO2) Hydrogen chloride (HCl) Oxides of nitrogen (NOx)

Additional instructions

Combustion residues and contaminated extinguishing media must be disposed of in accordance with the local authority regulations. Collect contaminated extinguishing water separately, do not allow it to run into the drains.

6. Measures if inadvertently released

Personal precautions

Ensure sufficient ventilation. Wear protective clothing.

Where vapours/dust/aerosols are present, wear a breathing mask. Environmental protection measures

Do not allow to run into the drains or bodies of water.

In the event of penetration into water, ground or drains, inform the responsible authorities!

Procedure for cleaning/clearing up

Absorb with media that bind to liquids (e.g. sand, sawdust, universal binding media. Dispose of the material that has been cleared up in accordance with the section on Disposal.

7. Handling and storage

Handling

Instructions for safe handling:

Refer to Section 8 / Personal protective

 

equipment.

Instructions for fire and explosion prevention: Not applicable

Storage

Requirements for storerooms and containers:

Containers should be dry, kept tightly sealed and stored in a cool, well ventilated place. Storage proximity instructions

Store separately from all kinds of foodstuffs. Additional instructions for storage

Protect against frost.

Protect against heat and direct sunlight.

Protect against atmospheric humidity and water.

* 8. Exposure limitation and personal protective equipment

Components subject to monitoring of workplace concentration limits

 

 

Designation of the component

 

 

CAS no.

type

 

Reference/country/year

Naphtha (crude oil), hydro-desulphurised heavy

 

 

64742-82-1

Permissible workplace concentration

350 mg/m3

TRGS 900/DE/2004

64742-82-1

Permissible workplace concentration

70 ml/m3

TRGS 900/DE/2004

32

*) Markings (*) in the left margin indicate revisions from the previous version.

Image 32
Contents CAP General Company Address and Accredited RepresentativeMobiset 4 CAP 910 Components / Scope of Delivery Product PackageContents Installation Manual Contents Operating Manual Proper USE Proper USE USE for the Intended PurposeAdhesive sealant Safety Instructions Important NotesEssential information Power supply, fusing Road Traffic Licensing Regulations StVZOChecks before commencing a journey Installation and Connection Selecting the Installation LocationRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Figure C Not included Installation of Turntable Variant with Cable Gland Underneath the TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Installation of the UFS 940SW Selection of a Suitable Installation LocationPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Connection Example for 12 V Battery Connection Receiver. There is no restriction onReception Range / Footprint Address of the Service Centre Dismantling for ServicingDismantling ESCSafety Instructions Manual Lowering to Park PositionManual Lowering Technical Specifications Direction of travelSikaflex 291 Safety Data Sheet Materials/preparation and company designationComposition/data on components Potential hazardsMeasures for fire fighting Measures if inadvertently releasedHandling and storage Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityToxicology data Sensitisation Ecological dataDisposal instructions Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaflex-291 IkaflexChemical Stability CAP CAP 910 Operating ManualImportant Information for CAP 910 Before Setup Remote ControlFirst Installation Hdmi Video System Local time offset UTC Automatic clock change summer/winter timeCAP Menu Turntable Antenna Settings Resetting the CAP System Turntable Antenna ResetCalling UP the CAP Menu All satellite positions found by a search will be deletedElevation Inputting the CAP GPS PositionTo Move the Antenna Manually Move to the Azimuth Rotate the Antenna Stop on SignalLNB TILT/SKEW CAP Settings Move CAP to Park PositionElevation Border and Elevation Offset Search SpeedRestore Factory Settings Countdown for the Search StartAlignment Satellite Search Channel Satellite SELECTION/PROGRAMMING the Timer Channel Selection from the Channel ListTimer Programming Channel Selection from the Channel List Sorted by SatelliteChange of Location Change of Location Park Parking the TurntableSpecial Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further MessagesTimer function is currently not yet available in CAP mode Declaration of Conformity Disposal Instructions Spent batteries are special waste