Kathrein cap910 manual CAP Menu Turntable Antenna Settings, Calling UP the CAP Menu

Page 44

CAP MENU (TURNTABLE ANTENNA SETTINGS)

CALLING UP THE CAP MENU

Press the (green) button. The following display appears:

Use the  buttons to select the “Antenna Conﬁguration” line and press

the button to conﬁrm.

The following display appears:

You can also call up this menu via the main menu “Settings”, “Antenna Conﬁguration” (System: CAP).

RESETTING THE CAP SYSTEM (TURNTABLE ANTENNA) (RESET)

All satellite positions found by a search will be deleted.

Use the  buttons to select the “Reset turn table antenna” line and press the  button to conﬁrm. The following display appears:

Press the button to conﬁrm, or the button to cancel.

Note: Before exchanging any component of the system (such as the receiver) the turntable should be moved to its park position by means of the “Reset turn table antenna” command. The “Reset” deletes all previously saved satellite positions. The satellite data in the UFS 940sw receiver are however retained.

44

Image 44

Contents CAP General Company Address and Accredited RepresentativeMobiset 4 CAP 910 Components / Scope of Delivery Product PackageContents Installation Manual Contents Operating Manual Proper USE Proper USE USE for the Intended PurposeAdhesive sealant Safety Instructions Important NotesEssential information Power supply, fusing Road Trafﬁc Licensing Regulations StVZOChecks before commencing a journey Installation and Connection Selecting the Installation LocationRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Figure C Not included Installation of Turntable Variant with Cable Gland Underneath the TurntableFigure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Installation of the UFS 940SW Selection of a Suitable Installation LocationPreparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Connection Example for 12 V Battery Connection Receiver. There is no restriction onReception Range / Footprint Address of the Service Centre Dismantling for ServicingDismantling ESCSafety Instructions Manual Lowering to Park PositionManual Lowering Technical Specifications Direction of travelSikaflex 291 Safety Data Sheet Materials/preparation and company designationComposition/data on components Potential hazardsMeasures for ﬁre ﬁghting Measures if inadvertently releasedHandling and storage Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityToxicology data Sensitisation Ecological dataDisposal instructions Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaﬂex-291 IkaflexChemical Stability CAP CAP 910 Operating ManualImportant Information for CAP 910 Before Setup Remote ControlFirst Installation Hdmi Video System Local time offset UTC Automatic clock change summer/winter timeCAP Menu Turntable Antenna Settings Resetting the CAP System Turntable Antenna ResetCalling UP the CAP Menu All satellite positions found by a search will be deletedElevation Inputting the CAP GPS PositionTo Move the Antenna Manually Move to the Azimuth Rotate the Antenna Stop on SignalLNB TILT/SKEW CAP Settings Move CAP to Park PositionElevation Border and Elevation Offset Search SpeedRestore Factory Settings Countdown for the Search StartAlignment Satellite Search Channel Satellite SELECTION/PROGRAMMING the Timer Channel Selection from the Channel ListTimer Programming Channel Selection from the Channel List Sorted by SatelliteChange of Location Change of Location Park Parking the TurntableSpecial Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further MessagesTimer function is currently not yet available in CAP mode Declaration of Conformity Disposal Instructions Spent batteries are special waste