Controls, Displays and Connections
Important information on the remote control
You can only operate the UFD 170 using the remote control (RC 400) supplied. Without the remote control, it is not possible to set up or control the receiver and the turntable. Therefore, you should always take good care of your remote control and make sure you have spare batteries for it.
Remote control instruction sets
The remote control has two instruction sets. This alllows you to operate two receivers independently of one another in the same room.
Note: | This does not work in conjunction with a twin receiver! |
To use this feature, program the fi rst receiver to instruction set 1 and the second to instruction set 2.
First turn on receiver 1 and then receiver 2 using the power switch.
Hold down the key.
Enter “901” using the number keys.
To transfer the code, switch receiver 1 to standby with , and then turn the unit off with the power switch.
Start up receiver 2 again.
Hold down the key.
Enter “902” using the number keys.
To transfer the code, switch receiver 2 to standby with , and then turn it back on.
Start up receiver 1 again.
Hold down the key.
Enter “903” using the number keys.
For the fi rst two settings, the remote control must be pointed at the relevant receiver turned on.
You can now use the key to change between the two instruction sets A and B (toggle function), and operate the two receivers alternately.
As supplied, instruction set 1 is always activated by default.
If you are only operating one receiver, and the active instruction set is accidentally changed so that you can no longer operate the receiver, the remote control can be switched back to instruction set 1 with no problems. This procedure is described above.
12