Kathrein UFD 170 manual Opening the Installation Menu, LNB Configuration, Oscillator Frequency

Installation Menu

You should not change the following settings without a good reason, as they are factory settings or operating settings that are tailored to your receiving system. New settings are only required if the reception system is changed or expanded.

Opening the Installation Menu

You reach the installation menu from the main menu (called up with the  key) by using the  keys to navigate to “Installation Menu” and then pressing the  key to open.

LNB Configuration

	If the UFD 170 is being operated in conjunction with the Kathrein
	turntable, nothing may be changed in the “LNB Confi guration”
	menu. Changes to these settings would result in the assignment
	being lost, and the turntable would not longer be able to fi nd the
	satellites.
	Use the  keys and the  key to select the LNB
	Confi guration option.
Note:	Before every change, you should note the settings on the form at the
	end of the operating manual. The satellites listed under the Receiver
	Factory Satellite Settings option are preset in the factory

L.O. Oscillator Frequency

Satellite receiver systems consist of a parabolic antenna attached to the actual receiving system (LNB or LNC), which converts the RF signal from the satellite into a lower frequency, which can be processed by a satellite receiver.

The satellite transmission frequencies are located in the following

ranges:
10.7-11.7	GHz	Low band
11.7-12.75	GHz	High band

50