Installation Menu
You should only make changes in this menu if the receiver is connected to a different receiving system with different properties or if changes have been made to the receiving system.
You should therefore carefully follow the instructions for your satellite system. However, before each change you should note the settings on the form at the end of this operating manual.
You reach the “DiSEqC[UFO] Setup” menu using the
keys and the key in the Installation menu.
22 kHz Signal
This menu option is used to specify whether the 22 kHz signal is to be used to switch between the upper and lower frequency ranges for a satellite (low/high) or between two satellite positions.
Tone Burst and DiSEqCTM Signal
If more than four control criteria are requried in a receiving system, a
DiSEqC™ control signal is required.
Which of the setting options - Tone Burst or DiSEqC™ - is required depends on the components of the receiving system.
You should therefore refer to the descriptions of the existing components (switching matrices) of the receiving system.
Switching states for setting: |
| Switching states for setting: |
| Switching states for setting: |
| |||
22 kHz Signal | High/Low | 22 kHz Signal | Pos. A/B: | 22 kHz Signal | Pos. A/B: | |||
and |
|
| and |
|
| and |
|
|
Tone Burst | Pos. A/B: | Tone Burst | Opt. A/B: | Tone Burst | High/Low | |||
Low | 22 kHz | Off | Pos | Tone Burst | 22 kHz | Low | Tone Burst | 0 |
High | 22 kHz | On |
|
|
| High | Tone Burst | 1 |
|
|
| 1 | 0 | Off |
|
|
|
Pos. 1 | Tone Burst | 0 | 2 | 0 | On | Pos. 1 | 22 kHz | Off |
Pos. 2 | Tone Burst | 1 | 3 | 1 | Off | Pos. 2 | 22 kHz | On |
|
|
| 4 | 1 | On |
|
|
|
DiSEqCTM
If the receiver is connected to a DiSEqC™ switching matrix, set the menu option to “On”.
The switching criteria and the input assignment of the DiSEqC™ switching matrices must be observed. You should therefore follow the description of the switching matrices or contact the engineer who installed the receiving system.
DiSEqCTM Repeat
If the receiver is operated in a receiving system with two or more
DiSEqC™ switching matrices connected in series (cascaded), the
DiSEqC™ command must be repeated.
In this case, set the DiSEqC™ Repeat menu option to “1” or “2”.
Default setting: “Off”
57