Kathrein UFD 170 manual Change of Location

Page 67

Change of Location

For slight changes of location, the antenna can find the satellite very quickly.

After a change of location, the antenna moves to the last position selected. After initialisation, you will therefore see the following display (example, as it depends on the position last selected):

If no signal is found at the last position, the following message

appears:

If you still want to aim at the satellite, press to start the search.

If a signal is found, the antenna automatically goes into the fi ne tuning mode (max. 90 seconds, if signal is adequate, the position is immediately saved).

After a successful search, the following message appears:

67

Image 67
Contents UFD Page Foreword Contents Connection Diagram Password and Child ProtectionSetting System Parameters Installation MenuContents Power supply cable Safety Instructions and Important InformationSAT-IF Connection Connection and SetupConnecting the Unit Receiving System PresetsDolby Connection Inserting Batteries in the Remote ControlTV Connection Audio ConnectionFront View Controls, Displays and ConnectionsFront View Rear View Exit Remote Control Function KeysRemote control instruction sets Important information on the remote controlMenu Concept Operating InstructionsLanguage Selection Key Alphanumeric Assignment of Remote Control Number KeysMenu Structure Important Information Initial SetupGetting Started Initial Setup Time/Timer section Receiver Factory Satellite SettingGeneral On Screen Display OSDHelp Function TV / Radio Channel Message Error MessageChannel Message Radio Video Text Selecting a TV or Radio Programme Programme SelectionReception Status TV / Radio Channel List Selecting TV/Radio Programmes by Number Switching from a TV Programme to a Radio ProgrammeInserting the Smartcard and the CA Module Common InterfaceMenu language Information for Conax, SECA, Viaccess and CryptoWorks Users Timer Settings VPS Signal Setting the Volume Audio SettingsStereo and Two-Channel Sound Playback Your Dolby Digital system Turning Off the Sound MuteEPG Electronic Programme Guide Programme Overview EPGEPG Timer Programming Selecting the Last Programmes Received Managing Channel List/ChannelsFavourite Channel Setting Up a Favourite ChannelRenaming the Favourite Lists Undoing Favourite Selection Selecting a Favourite Channel from a Favourite ListChannel List Mode Favourite, Satellite, Alphabetical Complete Channel List Sorting Channels Deleting Channels Adding Channels Manually Adding/Deleting Satellites Setting Up SatellitesDeleting Satellites Password Factory Setting Password and Child ProtectionSetting the Password and Child Protection Child Protection Locking a Channel Password and Child Protection Child Protection Setting System ParametersSystem Information TV Type Local Time/TimerPicture Format Mode ScreenOscillator Frequency Installation MenuOpening the Installation Menu LNB ConfigurationStandby OperationDiSEqC2 Setting DiSEqC1 SettingAntenna Setup Satellite Search Changing/Searching for/Deleting Transponders DiSEqCTM UFO Setup DiSEqCTM Repeat KHz SignalTone Burst and DiSEqCTM Signal DiSEqCTMRemote Frequency Factory SettingsReset does not delete the pre-programming After resetting, you may need to make all settings againSoftware and Programme List Update During the download, Please wait fl ashes on the screen Connection between Type of connection Connection DiagramOn-Board Network Connection SAT-ZF ConnectionControl Cable Initial Setup Information Important Information on the Turntable before SetupAlignment Satellite Search Manual Correction Alignment Satellite Search Change of Location Reset Reset/ParkPark System Protection Messages Special Messages for TurntableSatellite Lost / Limit Reached Using the  key Turntable Unit Software Download Turntable Unit Software Download Manual Lowering to Park Position Safety InstructionsManual Retraction Service DVB GlossaryEb/No ratio Brief Technical GlossaryDiSEqC components Dolby DigitalVideo bit rate Symbol rateProgramme package Transponder936.2705/B/0505/ZWT Subject to technical changes