Connection Diagram
SAT-ZF Connection
The coaxial cable coming from the antenna is connected to the SAT-IF input on the UFD 170. The SAT-IF output on the UFD 170 control unit is already connected to the SAT-IF input on the UFD 170 receiver with the coaxial cable supplied. The correct sequence must be observed due to the power supply for the LNB (via coaxial cable) and communication between the two boards in the UFD 170 (control unit and receiver).
On-Board Network Connection
In terms of the on-board network connection, refer to the information in the installation manual for the CAP 210/310.
The power supply cable supplied (wires: brown/white/green) is connected directly to the battery (battery strip before fuse). The brown wire is connected to “+”, the white wire to “-” and the green wire to the ignition behind the ignition lock, so that it is under power as soon as the ignition is switched on. Make sure that the “+ 12 V”, “earth” and “ignition” wires cannot be interrupted by switches connected in series, as this can disable the function for automatic lowering of the antenna.
The green connection is important as it is the only way to ensure that the turntable moves to park position when the ignition is switched on. This prevents driving with the antenna extended.
If the supply voltage is too low, the UFD 170 receiver displays the OSD message “On-board voltage too low”. If the on-board voltage is too low, other error messages can also appear (e.g. “Overload”, even though there is no overload).
Control Cable
The control cable for the turntable is connected to the UFD 170 (see previous page).