Kathrein UFD 170 manual Manual Correction

Alignment (Satellite Search)

After successful fi ne-tuning, the following message appears for a few seconds:

The set position (the satellite found) is saved.

Manual Correction

At the margins of the footprints of a satellite (e.g. after a slight change of position), it may be necessary for you to manually correct the setting (not normally required). It is also possible to manually correct the fi ne tuning.

Press  in the main menu and then use the  keys to switch to the “HDP antenna setup” option. Then press

to go to the HDP menu.

You can correct the inclination and horizontal angle of the antenna using the “Elevation” and “Azimuth direction” settings. To do this, press

the  keys or enter a fi gure using the number keys and confi rm

with . Check your settings by referring to the “Level” and “Qual” bars on the left-hand side. The higher the bar, the stronger and better

quality the signal received. At the same time, you can use the  key to activate a search tone, the level of which corresponds to the signal strength. The graphical display in the lower section of the screen (green with red dot) represents the relative position of the antenna.

While the antenna turntable is moving in the desired direction, a cor- responding message for Elevation and Azimuth direction appears (ex- ample).

65