Kathrein UFD 170 manual Receiver Factory Satellite Setting, Time/Timer section

Initial Setup

This message appears when “HDP mode” is deactivated.

Press  to switch to the main

menu, and then use the  keys to call up the “HDP Antenna Se-

tup” sub-menu. Use the keys to change the selection to “On”. Pres-

sing the keys takes you back to the normal TV screen.

Time/Timer” section).

If the message “ Poor or no signal” appears on the screen as well as the display for the last programme received, check the installation of the system and/or the receiver settings. If this only affects individual programme slots, there may be an interrupted signal from the broadcaster or a fault in the reception system.

First of all, check the connection confi guration and whether the default receiver settings are correct for your system. In case of doubt, consult a specialist engineer.

Receiver Factory Satellite Setting

Your receiver is factory-set up for the satellites listed in the following table. You do not normally need to make any additional settings.

ASTRA	HOTBIRD	EUTELSAT	EUTELSAT
19° East		10° East	16° East
TürkSat	Telecom	Telecom	ASTRA 28.2°
42° East	5° East		East (EURO-
		8° East
(EURASIA)	(AtlanticBird 3)		BIRD 28.5°)
Telestar12	Hisparsat	EUTELSAT	Amos 4° West
15° West	30° West	7° East
Thor 1° West	Sirius 5° East	Arabsat
(Intelsat 707)		26° East

18