Sylvania 3819LC owner manual Preparation for USE, Antenna/Cable, VHF/UHF Separate Antennas

PREPARATION FOR USE

ANTENNA/CABLE	VHF/UHF SEPARATE ANTENNAS
CONNECTIONS	In some areas it will be necessary to use an outdoor antenna.

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (not supplied) is detach- able. Insert the stem of the antenna into the hole on the upper-back portion of the TV/VCR.

Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/VCR as shown in the diagram below.

For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

NOTE :

Before plugging the Rod antenna into antenna terminal, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into antenna terminal.

Bent pin

Cable	Plug
(Needs to be straightened)		(Straight pin)
	Rod Antenna	VHF/UHF Antenna
	(Not supplied)
	T
		[Fig.4]
NOTE:

The connection of an indoor antenna may not always give acceptable TV reception.

VHF Antenna
UHF Antenna
VHF/UHF
Combiner
(Not
supplied)
ANT
Flat twin-lead cable	[Fig.5]

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box.

By using this connection you can:

1)Use the TV/VCR remote to select channels

2)Program one or more unscrambled channels for Automatic Timer Recording.

NOTE: This unit will ONLY record and view the same

channel.

From Cable System

75-ohm

Coaxial Cable

(not supplied)

ANT

ANT

[Fig.6]

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

Antenna/Cable Connections Continued on the Next Page.

- 10 - EN

8E21