OTR (One Touch Recording) 
This function enables you to set a recording length simply by pressing the REC/OTR button on the TV/VCR.
Make sure ...
●TV/VCR power must be turned on.
●Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)
NOTES:
●This function CANNOT be done from the remote control.
●Recording starts immediately when the REC/OTR button is pressed.
●When the REC/OTR button is pressed 18 times, the TV/VCR returns to the Normal Recording mode.
●To stop the OTR operation, press the STOP button on the TV/VCR or on the remote control.
●To show the remaining time, press the DISPLAY button on the remote control so that "OTR" appears on the TV screen. (It will show up momentarily then disappear.)
●Recording stops when 0:00 is reached.
●Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using
●If the tape runs out before the end time, the TV/VCR will switch to the Stop mode immediately, ejects the tape and turns itself off.
1Select the channel to be recorded
Press the number buttons on the remote control or the CHANNEL ▼ or ▲ button.
Remember: If the TV/VCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box.
COPYING A VIDEO CASSETTE (Requires a VCR or video camera)
You can make copies of video tapes made by friends or relatives for your enjoyment.
WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.
Connect your TV/VCR and a Source (Playing) VCR using the following diagram.
|
| [Fig.8] |
AUIO | IEO |
|
EARPHONE |
|
|
| [The TV/VCR] | |
[Ex: Source (Playing) | ||
VCR or video camera] | ||
Audio/Video | IEO |
|
|
| |
adapter cable | OUT | IN |
(not supplied) | AUIO |
|
|
| |
1) | Insert a |
| (Playing) VCR or video camera. |
2) | Insert a blank video cassette, or one you want to record |
| over, into the TV/VCR’s cassette compartment. |
3) | Press the SPEED button on remote control for the |
| TV/VCR to select the desired recording speed |
| (SP/LP/SLP). |
2Begin OTR
Press the REC/OTR button on the TV/VCRasmanytimesasneeded. The recording length will be determined by the number of times you press the REC/OTR button. Each additional the recording time by 30 minutes. It
OTR ( 2 : 3 0 )
SP
push will increase is set up to 8 hours.
4) | Press the CHANNEL ▲ or ▼ button on the TV/VCR |
| until "AUX" appears on the screen. |
5) | Press the RECORD button on the TV/VCR. |
6) | Begin playback of the tape in the source (Playing) |
| VCR or video camera. |
NOTE: For best results during dubbing, use the TV/VCR’s front panel controls whenever possible. The
Push(es) | Display | Recording length |
1 push | (normal recording) | |
2 pushes | 0:30 | 30 minutes |
3 pushes | 1:00 | 60 minutes |
↓ | ↓ | ↓ |
|
|
|
17 pushes | 8:00 | 480 minutes |
remote control might affect the source (Playing) VCR’s playback operation.
- 23 - | EN |
7L26