Emerson EC313D Preparation for USE, ANTENNA/CABLE Connections, VHF/UHF Combined Antenna

PREPARATION FOR USE

ANTENNA/CABLE

CONNECTIONS

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (supplied) is detach- able. Insert the stem of the antenna into the hole on the upper-back portion of the TV/VCR.Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/VCR as shown in the diagram below.For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

NOTE:

Before plugging the Rod antenna into antenna termi- nal, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into antenna terminal.

Bent pin

Cable	Plug
(Needs to be straightened)		(Straight pin)
	Rod Antenna	VHF/UHF Antenna
	(Supplied)
		(Not supplied)
DC 13.2V	AC 120V
		.
ANT.
NOTE:

The connection of an indoor antenna may not always give acceptable TV reception.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

	VHF Antenna (Not supplied)
	UHF Antenna
	(Not supplied)
	VHF/UHF
DC 13.2V	Combiner
	AC 120V
	(Not
ANT.	supplied)
ANT.
	Flat twin-lead cable

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can:

1)Use the TV/VCR remote to select channels.

2)Program one or more unscrambled channels for Automatic Timer Recording.

NOTE: This unit will ONLY record and view the same channel.

From Cable System

75-ohm Coaxial

Cable (Not

supplied)

DC 13.2V

AC 120V

ANT.

ANT.

Antenna/Cable Connections Continued on the Next Page.

- 10 - EN

0B19