|
| Table 9. Set Up Library Menu Selections | |
|
|
|
|
| Menu Selection |
| Description |
1 Config Information |
| Allows viewing and editing of library configuration settings. | |
|
|
|
|
1 | Unit Information/Config |
| To view the storage slot count, drive count, and firmware revision. |
|
|
|
|
2 | Serial Number |
| To view the serial number assigned to the library. |
|
|
|
|
3 | Date and Time |
| To view/edit the current date and time settings. |
|
|
|
|
4 | SCSI Bus Config |
| To view the current SCSI bus configuration. |
|
|
|
|
5 | Changer Address |
| To view/set the changer SCSI ID. |
|
|
|
|
6 | Drive Addresses |
| To view/set individual drive SCSI IDs. |
|
|
|
|
7 | Changer Options |
| To view/edit changer options: |
|
|
|
|
| Disable Tray Return |
| Disables return of media trays to their magazines when entering Magazine |
|
|
| Exchange mode. |
|
|
|
|
| Tray Return On Power |
| Enables the return of media trays to the magazines upon library power on. |
|
|
|
|
| Disable Auto LD/EJ |
| Disables auto clamping and unclamping of the media tray. |
|
|
|
|
| Ignore Recover Errs |
| If library can recover from an error, it will keep operating and not report the |
|
|
| error. |
|
|
|
|
| Limit Recovery |
| To limit error recovery effort to four tries. |
|
|
|
|
| Enable All UATTN |
| Enable all unit attention conditions to host. |
|
|
|
|
8 | Passwords |
| To set or change passwords. To remove password protection from a menu |
|
|
| selection, press the check mark without entering any letters. The factory |
|
|
| default password is AAAA. If a password is forgotten or lost, please contact |
|
|
| Plasmon support. |
|
|
|
|
9 | RMI Information |
| Not supported. |
|
|
| |
2 Status Information |
| Allows viewing/editing of library status. | |
|
|
|
|
1 | Element Status |
| To view/edit which elements (slots, drives, pickers, or I/O stations) are pop- |
|
|
| ulated by media trays. Individual slot status can be set to full or empty. |
|
|
|
|
2 | Drive States |
| To view a drive’s on/off state. |
|
|
|
|
3 |
| To view total hours of power to library. Useful for preventive maintenance. | |
|
|
| Cannot be reset. |
|
|
|
|
4 | Unit Cycle Count |
| To view total cycle count since first startup. Cannot be reset. |
|
|
|
|
5 | Drive Load Counts |
| To view/reset total drive loads since last reset of count. |
|
|
|
|
Menu System | Plasmon D875 - D2175 User Manual |
Page 48 | Document Revision E |