Plasmon D875, D2175 user manual Appendix D

Error	Sub-	Error	Subcode	Compo-	Corrective Action
Code	code	Description	Description	nent
(hex)
	2		Lift offset too many
			counts greater than
			nominal
	3		Lift offset less than neg-
			ative physical bound-
			ary count
	4		Lift offset greater than
			positive physical
			boundary count
C3	1	Pivot offset fail-	Pivot offset too many	Pivot flags,	Verify pivot flags OK, pivot
		ure	counts less than nomi-	pivot circuit	sensors working, pivot gear
			nal	board, pivot	mesh is not too tight
				cable, pivot
				gear mesh
	2		Pivot offset too many
			counts greater than
			nominal
	3		Pivot offset less than
			negative physical
			boundary count
	4		Pivot offset greater than
			positive physical
			boundary count
C4	1	Offset target fail-	Target could not be	Offset target,	Verify offset targets not dam-
		ure	found	offset sensor	aged, Offset sensor is work-
				on MTE	ing or replace MTE
	2		Target horizontal posi-
			tion found crudely, but
			not with fine resolution
	3		Target vertical position
			found crudely, but not
			with fine resolution
	4		Reference target not
			found
C5	1	Offset ref failure	Reference could not be	Offset refer-	Verify reference sensor work-
			found	ence sensor	ing, Replace MTE or detec-
					tor in chassis
	2		Reference vertical posi-
			tion found crudely, but
			not with fine resolution

Plasmon D875 - D2175 User Manual	Appendix D
Document Revision E	Page 83