Plasmon D875, D2175 user manual Appendix D

Error	Sub-	Error	Subcode	Compo-	Corrective Action
Code	code	Description	Description	nent
(hex)
	4		Picker is 2nd destina-
			tion element, src ele-
			ment = 2nd dest
			element
86	1	Element unexp	No trays to use in cycle		Run Check Elements
		empty	Full test
	2		Tray not seen during
			pick attempt
87	1	Element unexp	Home sensor blocked	Obstruction	Check path, run offsets
		full	after store attempt	in path, Align-
				ment problem
	2		Picker is full, attempting
			to return tray to last ele-
			ment
8B	1	Picker is full	VP or Pemt sensor	Firmware,	Tray in picker while picking,
			blocked by tray moving	Picker faulty	initialize and retry, replace
			to the pick position		picker
	2		VP or Pemt sensor
			blocked moving to the
			unload drive position.
	3		Both pickers are not
			empty to do an
			exchange (during
			check move)
	4		Picker full, not a move
			to Lift and from Lift (dur-
			ing check move)
	5		SCSI exchange 2nd
			destination picker,
			source not picker
8C	1	Both pickers full	Check move, NVRAM	Main control-	Firmware recovery issue,
			says both pickers full	ler circuit	replace Main controller cir-
				board, firm-	cuit board
				ware
	2		Check single element,
			NVRAM says both pick-
			ers full
	3		SCSI Mag door open,
			both pickers full so
			magazine can't be
			checked

Plasmon D875 - D2175 User Manual	Appendix D
Document Revision E	Page 79