Plasmon D2175, D875 user manual Appendix D Document Revision E

Error	Sub-	Error	Subcode	Compo-	Corrective Action
Code	code	Description	Description	nent
(hex)
	5		Checking a SCSI posi-
			tion to drive command
32	1	Drive not con-	Drive not connected	Drive inter-	Replace or reconnect drive
		nected	that was previously	face cables	cables
			installed
	2		Drive not connected
			when restoring drives
33	1	Drive clamp fail	Drive clamp fail while	Drive, drive	Replace drive or cabling
			loading drive	cables
34	1	Drive unclamp	Drive unclamp fail	Drive, drive	Replace drive or cabling
		fail	unloading drive retry	cables
35	1	Drive load fail	Tray not seen in picker	MTE sensor	Replace MTE
			while picker moving to
			load position
	2		VP or Tray sensor	MTE sensor,	Replace MTE, VP sensor, run
			blocked after retracting	VP sensor	offsets to correct positioning
			picker to fwd position
	3		Drive not set to loaded
	4		Drive load retry aborted
36	1	Drive unload fail	Drive not unclamped	Drive, drive	Replace drives or cables
				cables
	2		Pick finger did not hold	Alignment	Run offsets
			on to tray, VP or Tray	problem
			sensor blocked
	3		No tray seen in unload	Alignment	Run offsets, replace MTE
			attempt	problem,
				MTE tray
				sensor
	4		Picker Tray sensor	Alignment	Run offsets, replace MTE
			blocked during tray only	problem,
			check of drive unload	MTE tray
				sensor
	5		Picker Tray sensor	Alignment	Run offsets, replace MTE
			unblocked during tray	problem,
			only check of drive	MTE tray
			unload	sensor
37	1	Drive is clamped	Drive is clamped, can't	Drive, drive	Replace Drive, drive cables
			unclamp (checking	cables
			move from a drive)

Appendix D	Plasmon D875 - D2175 User Manual
Page 72	Document Revision E