Plasmon D2175, D875 user manual FS Eeprom

Error	Sub-	Error	Subcode	Compo-	Corrective Action
Code	code	Description	Description	nent
(hex)
8D	1	No media to flip-	No media in tray to flip-	Need media	Provide media for use
		per	per for move medium
			command
	2		No media in source ele-
			ment to flipper for
			exchange medium
			command
	3		No media in destina-
			tion element to flipper
			for exchange medium
			command
90	1	Tray in drive	Tray in a drive while	Drive	Drive has tray, either in ser-
			attempting to park		vice mode, or bad drive
9C	1	Tray magazine	Source magazine for		Recovery
		unknown	tray unknown when
			returning trays to there
			last known elements
9D	1	Element scan	Failed to position lift or	Alignment	Run offsets
		fail	picker properly while	problem
			checking elements.
	2		Invalid Element (current
			element check)
B2	1	Flipper invalid	Both flipper home sen-	Flipper	Replace flipper
		position	sors blocked
B3	1	FS EEPROM	Write flipper EEPROM	Flipper, mag	Replace flipper or mag inter-
		write fail	status failed	interface cir-	face
				cuit board
B4	1	Missing flipper	No tray in flipper		Replace tray
		tray	(at least one required)
B5	1	Flipper is full	Both slots of flipper		Remove tray
			have trays
B6	1	Flipper comm	Time out for flipper sta-	Flipper, mag	Replace flipper or mag inter-
		error	tus command	interface cir-	face
				cuit board
	2		Time out for flipper read
			version command
	3		Time out for flipper read
			sensors command

Appendix D	Plasmon D875 - D2175 User Manual
Page 80	Document Revision E