EN

 

85

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SYMPTOM

 

POSSIBLE CAUSES

CORRECTIVE ACTION

 

 

45. The LCD monitor, the

45.

 

 

45. •Wipe them gently with soft

 

 

viewfinder and the lens

 

 

————

cloth. Wiping strongly can

 

 

have become dirty (ex.

 

 

 

cause damage (pg. 92).

 

 

fingerprints).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

46. An unusual mark appears.

46.

 

 

46. •Check the section of the

 

 

 

 

 

————

manual that explains LCD

 

 

 

 

 

monitor/viewfinder

 

 

 

 

 

 

 

 

 

 

 

 

indications (pg. 88 – 91).

 

 

 

 

 

 

 

47. An error indication

47. •A malfunction of some kind

47. •Remove the power supply

 

 

(E01 — E06) appears.

 

has occurred. In this case

(battery pack, etc.) and wait a

 

 

 

 

the camcorder’s functions

few minutes for the indication

 

 

 

 

become unusable.

to clear. When it does, you

 

 

 

 

 

 

can resume using the

 

 

 

 

 

 

camcorder.

 

 

 

 

 

 

If the indication remains even

 

 

 

 

 

 

though you repeat the above

 

 

 

 

 

 

two or three times, please

 

 

 

 

 

 

consult your nearest JVC

 

 

 

 

 

 

dealer.

 

 

 

 

 

 

 

48. The charger indicator on

48. •The temperature of the

48. •To protect the battery, it is

 

 

the AC Power Adapter/

 

battery is extremely high/low.

recommended to charge it

 

 

Charger does not light.

 

•Charging is difficult in

in places with a temperature

 

 

 

 

places subject to extremely

of 10°C to 35°C (pg. 93).

 

 

 

 

high/low temperatures.

 

 

 

 

 

 

 

 

 

 

 

49. Picture does not appear on

49. •The viewfinder is pulled

49. •Push the viewfinder back in.

 

 

the LCD monitor.

 

out.

•Adjust the brightness of the

 

 

 

 

•The LCD monitor's

LCD monitor (pg. 16).

 

 

 

 

brightness setting is too

•If the monitor is tilted

 

 

 

 

dark.

upward 180 degrees, open

 

 

 

 

 

 

the monitor fully (pg. 16).

 

 

 

 

 

 

 

50. When the image is printed

50. •This is not a malfunction.

50. •By recording with “DIS”

 

 

from the printer, a black

 

 

 

activated (pg. 32) this

 

 

bar appears at the bottom

 

 

 

can be avoided.

 

 

of the screen.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

51. When the camcorder is

51. •The DV cable was plugged/

51. •Turn the camcorder’s power

 

 

connected via the DV

 

unplugged with power

off and on again, then

 

 

connector, the camcorder

 

turned on.

operate it.

 

 

does not operate.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

52. During transport, the lens

52.

 

 

52. •Do not subject the

 

 

cover opens.

 

 

 

camcorder to shock or

 

 

 

 

 

————

excessive vibration during

 

 

 

 

 

transport.

 

 

 

 

 

 

 

 

 

 

 

 

•Turn the camcorder on and

 

 

 

 

 

 

off. The lens cover closes.

 

 

 

 

 

 

 

 

 

 

 

Page 85
Image 85
JVC GR-DVL9800 LCD monitor, Viewfinder and the lens, Have become dirty ex, Fingerprints, Camcorder’s functions, Transport