IBM 201 manual Viewing the test log, Diagnostic error message tables

Viewing the test log

The test log will not contain any information until after the diagnostic program has run.

Note: If you already are running the diagnostic programs, begin with step 4

To view the test log:

1.Ensure a monitor, keyboard, and mouse is connected to the NAS 200.

2.Power on the NAS 200 engine and watch the screen.

If the NAS 200 engine is on, shut down your operating system and restart the engine.

3.When the message F2 for Diagnostics appears, press F2.

If a power-on password or administrator password is set, you will be prompted for it. Type in the appropriate password, then press Enter.

4.When the Diagnostic Programs screen appears, select Utility from the top of the screen.

5.Select View Test Log from the list that appears; then, follow the instructions on the screen.

The system maintains the test-log data while the NAS 200 is powered on. When you turn off the power to the NAS 200, the test log is cleared.

Diagnostic error message tables

Table 18 describes the error messages that might appear when you run the diagnostic programs.

Important: If diagnostic error messages appear that are not listed in Table 18, make sure that your appliance has the latest levels of BIOS, Integrated System Management Processor, ServeRAID, and diagnostics microcode.

In the following error codes, if XXX is 000, 195, or 197, do not replace a part.

These error codes have the following meanings:

000The test passed.

195Esc was pressed to end the test.

197This is a warning error and may not indicate a hardware failure.

For all other error codes, replace the part or perform the actions indicated.

Table 18. Diagnostic error messages

Error Code	Meaning	FRU/action
001-XXX-000	Failed core tests	System board
001-XXX-001	Failed core tests	System board
001-250-000	Failed System board ECC	System board
001-250-001	Failed Processor board ECC	1.	Processor/PCI board
		2.	System board
005-XXX-000	Failed Video test	System board
011-XXX-000	Failed COM1 Serial Port test	System board
011-XXX-001	Failed COM2 Serial Port test	System board

100NAS 200 User’s Reference