IBM 201 manual Error

Table 17. POST error messages (continued)

Error	Meaning	FRU/action
code/Symptom
1600	The Service Processor is not	1.	Ensure that a jumper is not installed on J-51
	functioning
		2.	Remove the AC power to the system, wait 20 seconds
			and then reconnect the AC power. Wait 30 seconds; then,
			power-on the appliance.
		3.	System board
		4.	Processor/PCI board
1601	The system is able to	Suspected part:
	communicate to the Service	1.	Remove the AC power to the system, wait 20 seconds,
	Processor, but the Service
			and reconnect the AC power. Wait 30 seconds and
	Processor failed to respond
			power on the system.
	at the start of POST
		2.	Flash update the service processor.
		3.	System board
		4.	Processor/PCI board
1762	Hard-disk-drive configuration	1.	Run Configuration/Setup
	error
		2.	Hard disk cables
		3.	Hard disk adapter
		4.	Hard disk drive
		5.	SCSI backplane
		6.	System board
178X	Hard-disk-drive error	1.	Run diagnostics
		2.	Hard disk cables
		3.	Hard disk adapter
		4.	Hard disk drive
		5.	System board
1800	No more hardware interrupts	1.	Run Configuration/Setup
	available for PCI adapter
		2.	Failing adapter
		3.	System board
1962	Drive does not contain a	1.	Verify that a bootable operating system is installed.
	valid boot sector
		2.	Run diagnostics
		3.	Hard disk drive
		4.	SCSI backplane
		5.	Cable
		6.	System board
5962	IDE CD-ROM configuration	1.	Run Configuration/Setup
	error
		2.	CD-ROM drive
		3.	CD-ROM power cable
		4.	IDE Cable
		5.	System board
		6.	Battery
8603	Pointing-device error	1.	Pointing device
		2.	System board

Appendix C. Engine POST messages 95