IBM 201 manual Replacing the battery

9.You will be asked to choose the language you wish to use. Select your language (0-7) and press Enter to accept your choice. You will be prompted to remove the diskette and press Enter to restart the system. Remove the flash diskette from the diskette drive.

10.Power off the NAS 200.

11.Remove the jumper on the boot-block jumper block, or move it to pins 1 and 2 to return to normal startup mode.

12.Restart the NAS 200. It should start up normally.

Figure 2 shows the location of the boot block jumper on the system board.

System board

Switch block (SW1)

	SW1
1		ON
2
3
4
5
6
7
8

Flash boot block recovery jumper (J16)

Figure 2. Boot block jumper location

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you must adhere to the following instructions.

Note: In the U.S., call 1-800-IBM-4333 for information about battery disposal.

If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal components, be aware of the following environmental consideration. Batteries and accumulators that contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper manner.

To order replacement batteries, call 1-800-772-2227 within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM reseller or IBM marketing representative.

Note: After you replace the battery, you must reconfigure your appliance and reset the system date and time.

Chapter 7. Troubleshooting 59