IBM 201 manual To replace the battery

CAUTION:

When replacing the lithium battery, use only IBM Part Number 10L6432 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:

vThrow or immerse into water.

vHeat to more than 100 C (212 F)

vRepair or disassemble

Dispose of the battery as required by local ordinances or regulations.

Note: For translations of the safety notice, refer to the multilingual Safety Information on the Documentation CD that came with the appliance.

To replace the battery:

1.Review the information in the section “Before you begin” in the hardware installation guide that came with this appliance, and any special handling and installation instructions supplied with the replacement battery.

2.Turn off the appliance and peripheral devices and disconnect all external cables and power cords; then, remove the appliance cover.

3.Remove the battery:

a.Use one finger to lift the battery clip over the battery.

b.Use one finger to slightly slide the battery from its socket. The spring mechanism behind the battery will push the battery out toward you as you slide it from the socket.

c.Use your thumb and index finger to pull the battery from under the battery clip.

d.Ensure that the battery clip is touching the base of the battery socket by pressing gently on the clip.

Figure 3. Battery removal

4.Insert the new battery:

a.Tilt the battery so that you can insert it into the socket, under the battery clip.

b.As you slide it under the battery clip, press the battery down into the socket.

60NAS 200 User’s Reference