IBM 201 manual Error Code

Table 18. Diagnostic error messages (continued)

Error Code	Meaning	FRU/action
014-XXX-000	Failed Parallel Port test	System board
015-XXX-001	Failed USB test	System board
015-XXX-015	Failed USB external loopback	1.	Make sure parallel port is not disabled
	test	2.	Re-run USB external loopback test
		3.	System board
015-XXX-198	USB device connected	1.	Remove USB devices from USB1 and USB2
	during the USB test
		2.	Re-run USB external loopback test
		3.	System board
020-XXX-000	Failed PCI Interface test	System board
020-XXX-001	Failed Hot-Swap Slot 1 PCI	1.	PCI hot-swap latch assembly
	Latch test.
		2.	System board
020-XXX-002	Failed hot-swap slot 2 PCI	1.	PCI hot-swap latch assembly
	latch test
		2.	System board
020-XXX-003	Failed hot-swap slot 3 PCI	1.	PCI hot-swap latch assembly
	latch test
		2.	System board
020-XXX-004	Failed hot-swap slot 4 PCI	1.	PCI hot-swap latch assembly
	latch test
		2.	System board
030-XXX-000	Failed internal SCSI interface	System board
	test
035-XXX-099	No adapters were found	If the adapter is installed, recheck the connection.
035-XXX-S99	Failed RAID test on PCI slot	Note: Check the System Error Log before replacing a part.
	S	1.	Adapter
		2.	SCSI backplane
		3.	Cable
035-XXX-SNN	NN = SCSI ID of failing hard	Note: Check the System Error Log before replacing a
	disk	part.Hard disk drive with SCSI ID NN on RAID adapter in
		PCI slot S.
035-253-S99	RAID adapter initialization	1.	Obtain the basic and extended configuration status
	failure; ServeRAID Adapter in
			and refer to the ServeRAID Hardware Maintenance
	slot S is not configured
			Manual for more information
	properly
		2.	Adapter
		3.	SCSI backplane
		4.	Cable
075-XXX-000	Failed power supply test	Power supply
089-XXX-001	Failed microprocessor test	1.	VRM 1 for microprocessor 1
		2.	Microprocessor 1
089-XXX-002	Failed test for optional	1.	VRM 2
	microprocessor
		2.	Optional microprocessor 2
166-250-000	System Management failed:	1.	Reseat the I2C cables between Remote Supervisor
	(I2C cable is disconnected.
			Adapter (in PCI slot 1/J44) and system board (J45)
	Reconnect I2C cable
		2.	I2C cables
	between Remote Supervisor
	Adapter and system board.)

Appendix C. Engine POST messages 101