26
EN
RECORDING
Advanced
Features
For
Video
And
D.S.C.
(cont.)
Power Switch | Dual Shooting |
SNAPSHOT Button
Video image
Still image
OFF
Y
A
L
P
Y | D |
ALP CS | |
Lock Button
SNAPSHOT Button
Released position
position
position
Lets you record images on a tape and store still images in a MultiMediaCard simultaneously. In other words, it is possible to store still images in the MultiMediaCard without interrupting image recording on the tape.
1 Set the Shooting Mode Dial to “DUAL”, then set the Power Switch to “
” or “ 
” while pressing down the Lock Button located on the switch. Pull out the viewfinder fully or open the LCD monitor fully.
2 While recording to a tape, press SNAPSHOT halfway. A still image is displayed in the lower right corner of the screen where the video image being recorded is displayed.
•At this moment, if you release SNAPSHOT, snapshot recording will be cancelled.
3 Press SNAPSHOT fully. The displayed still image is stored in the MultiMediaCard.
NOTES:
●If SNAPSHOT is pressed in the
●If SNAPSHOT is pressed when “DIS” is set to “ON” (☞ pg. 32), the Stabiliser will be disabled.
●The Stabiliser is less effective in the DUAL mode than in other modes.
●The flash is disabled during video recording.
●Still images are stored in the MultiMediaCard in VGA mode file size (☞ pg. 15).
●When the Shooting Mode Dial is set to “DUAL”, all
Fade/Wipe Effects and some Programme AE with special effects cannot be used (☞ pg. 38 – 41).
Shooting Mode Dial
PS
VIDEO
DUAL
VGA
XGA
