Integra instruction manual Using Hdmi, Hdmi & the DPS-10.5, Video, Audio Formats

Connecting—Continued

Using HDMI

Use the supplied HDMI cable to connect the DPS-10.5’s HDMI OUT to an HDMI input on your AV receiver. Alternatively, you can connect the DPS-10.5 directly to the HDMI input on your TV.

HDTV, projector

HDMI

IN

HDMI

HDMI cable (supplied)

Signal flow

Notes:

•Use the Digital Out/Digital 2 settings to match the HDMI output format with your HDTV (see page 71).

•The DPS-10.5 supports HDCP (High-bandwidth Dig- ital Content Protection), a protection system for digital video. HDMI components that you connect to the DPS-10.5 must also support HDCP.

•The DPS-10.5 supports High-Definition Multimedia Interface Specification Information Version 1.0.

•See the tables on page 24 for details on how the DPS-10.5 outputs video and audio from its HDMI OUT socket.

HDMI & the DPS-10.5

■Video

The DPS-10.5’s HDMI OUT supports the following video resolutions:

•640 x 480p (VGA), 60 Hz

•720 x 480p (progressive), 60 Hz

•720 x 576p (progressive), 50 Hz

•1280 x 720p (progressive), 50/60 Hz

•1920 x 1080i (interlaced), 50/60 Hz

•Through Source Resolution (external input video is output at the same resolution. DVD playback is output at 480p or 576p)

If the connected HDTV or projector doesn’t support a resolution, you may get no picture.

When playing a DVD, or when watching an external video input source, the HDMI OUT works as follows.

Selected video input		HDMI OUTa
DVD playback (i.e.,		DVDb
DPS-10.5)
External	S VIDEO VIDEO IN	Externalb
	VIDEO VIDEO IN	Externalb

a.Only works with components that support HDCP (High-band- width Digital Content Protection).

b.Resolutions supported by the connected TV can be selected by pressing the [Resolution] button (see page 62).

On the DPS-10.5, you can select a resolution suitable for use with the connected HDTV or projector (see

page 62).

■Audio Formats

The DPS-10.5’s HDMI OUT supports the following audio formats:

•PCM (48 kHz, 44.1 kHz)

•Dolby Digital

•DTS

•MPEG

If your HDMI-compatible TV or projector doesn’t sup- port Dolby Digital, DTS, or MPEG, the HDMI OUT will not output digital audio in that format. In this case, set the Digital Out/Digital 2 setting (i.e., Dolby Digital Out, DTS Out, or MPEG Out) to downmix to PCM (see page 71).

To output 96 kHz PCM audio from a DVD-Video disc, set the Linear PCM Out setting to Down Sample On (see page 71).

Note that audio from DVD-Audio and SACD discs is not output by the HDMI OUT. For these formats you need to use the analog multichannel output (see page 33) or i.LINK (see page 31).

29