Integra DPS-10.5 instruction manual Setting Levels With the Test Tone, AV Synchronization

Configuring the DPS-10.5—Continued

Setting Levels With the Test Tone

1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select Test Tone, and
	then press the [Enter] button.
	The Test Tone settings appear onscreen.
Enter

AV Synchronization

When using progressive scanning you may find that the picture and sound are out of sync. With this setting you can delay the audio to correct this. There are three setup memories (1, 2, 3) for storing settings for up to three components. Memories 2 and 3 are already set at 50 ms, which is a good staring point when compensating for the video delay caused by a typical projector with a built-in scaler.

On	Standby	TV
	I	Input

2

Remote controller

Enter

Use the Up and Down []/[ ] buttons to select each speaker, press the [Enter] button, use the Left and Right []/[ ] buttons to adjust the levels, and then press the [Enter] button.

A test tone is output by each speaker as it is selected.

Speaker levels can be adjusted in 1 dB steps.

	1		2	3	+
					TV CH
	4		5	6	-
	7		8	9
					TV VOL
	+10		0	Clear
	Search	Memory Dimmer			Amp Input
	S		M	D	Input
			Amp Input
	DVD		V1	V2	V3
			Mode
	DVD		Amp	VCR	TV
	Zoom On				Picture Control
Enter	Audio		enu	M
		opM		enu
	Sel	T
	+
	CH
	Zoom		Enter		VOL
	L Mode
	-
		R	eturn	p
				Setu		Setup
	Display				Muting
	Last Memory		Step/Slow		Random
	Rec LM				RD
	Audio	Subtitle		Angle	Resolution
	Audio	Subtitle		Angle	Rsltn
	Repeat		A-B		Aspect
	Repeat		A-B		Aspect
	Video Input	Video Off		Learning
	V In		V Off	L1	L 2
	Open/Close

Speaker	Range	Default
Front Left
Center
Front Right	–12 dB to
		0 dB
Surround
	0 dB
Right
Surround Left
Subwoofer
You cannot set the level of speakers that
are set to Off.

3	When you’ve finished, press the
	[Setup] button to exit setup, or

Remote controller press the Left [] button repeat-

edly to go back to the main setup menu.

L 3	L 4
RC-562DV

Selecting the AV Synchronization

1 Use the Up and Down []/[ ] buttons to select setup 1, 2, or 3, and then press the [Enter] or Right [ ] button.

The parameters appear onscreen.

75