Integra DPS-10.5 instruction manual Controlling Other Components, Entering Remote Control Codes

Controlling Other Components

In addition to controlling the DPS-10.5, the remote con- troller can also be used to control your TV and VCR. To do this you need to enter the appropriate control codes for your TV and VCR. The remote controller can also learn individual commands from another remote control- ler (see page 87).

							Tx/Learn
Standby	On	Standby			TV		indicator
				I		Input
	1		2	3		+
Number						TV CH
	4		5	6		-
buttons	7		8	9
					TV VOL
	+10		0	Clear
Search		Memory Dimmer				Amp Input
	S		M	D		Input
			Amp Input
	DVD		V1	V2		V3	TV
			Mode
	DVD		Amp	VCR		TV
Zoom On					Picture Control		VCR
Audio			enu	M
		opM		enu
Sel		T
	+
	CH
	Zoom		Enter			VOL
	L Mode
	-
		R	eturn	p
				Setu
Display						Muting
Last Memory			Step/Slow			Random
Rec	LM					RD
	Audio	Subtitle		Angle	Resolution
	Audio	Subtitle		Angle		Rsltn
	Repeat		A-B			Aspect
	Repeat		A-B			Aspect
Video Input		Video Off		Learning
	V In		V Off	L1		L 2
Open/Close
				L 3		L 4
			RC-562DV

Entering Remote Control Codes

Entering the appropriate remote control code for your TV and VCR will allow you to control them with the DPS-10.5’s remote controller. You’ll need to perform this procedure twice to enter the codes for both your TV and VCR.

1		Look up the appropriate remote
		control code for your TV or VCR.
		See “Remote Control Codes” on
		page 83
2		While holding down the [VCR] or
		[TV] Mode button, press the
Remote controller		[Standby] button, and then
Mode		release both buttons.
	VCR TV
		The Tx/Learn indicator flashes slowly
		once, and then remains lit.
	Standby

3			Use the number buttons to enter
			the 4-digit remote control code.
Remote controller			If the code is accepted, the Tx/
1	2	3	Learn indicator flashes slowly
4	5	6	twice.
7	8	9	If the Tx/Learn indicator flashes
			quickly three times, the code has not
+10	0
			been accepted, in which case you

should try again from step 2.

Notes:

•The learning mode will be cancelled if you don’t press any buttons for 30 seconds.

•In some cases, not all of the remote controller’s but- tons may work as expected.

•Individually learnt commands for the TV and VCR modes (see page 87) are deleted when a new remote control code is entered.

82